WRT18A0AW4 Westinghouse Refrigerator - Instructions

I check why not defrost, y test element and tha problem is defrost timer, i ordered and change, that is it. Your intructions that is very nice.Thanks Ben

snapped the wires from frig onto the proper prong and viola,it works. The proper prong is identified by the size because there are two prongs with the wires and two connecting prongs in the socket. I talked to a very helpful representative and she gave me the number for Frigidaire, when I was confused by the placement of the wire. Wish I had remembered her name to share with you. As it turned out I didn't need to call Frigidaire.

Watch the video provided by PartSelect and did exactly the same percedure. Shows what screws to remove and how to remove and replace the part. The freezer compartment was iced up quite a bit so defrosted it before installing part.

The instructions given to me by part Select were very good.I replaced the Timer- checked the heater with oham meter it was good- checked the door weather striping it was good and replaced the thermostat with new .So at this point I may need to call a professional unless some one has another solution.

1 went with maj 69% said defrost timer. NO. 2 went with second choice run cap NO. 3 went with my thought, ( PTC Starter ) why not, most exp part. Fixed the problem.

Replaced broken section

Followed instruction vedeo from partselect. THANKS!!!!!

its real easy, just by pulling the old gasket, in some spots the gasket was like glued, but with a flat screw driver a managed to pulled apart. finally,just attached the new gasket.

Opened refrigerator door, opened a Corona, took a sip,removed old gasket from its track by simply pulling out of the track with my fingers; took another sip, installed new gasket by lining it up and pressing it into the track with my thumbs (It's good to have opposal digits) starting at the top center and progressing clockwise, closed refrigerator door, minus one Corona. Sat on the patio and enjoyed the rest of my Corona. Life's good!

Shipped quick. Assembled by hand. Mounted and tested operational.

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Used screwdriver to pry off edge of old gasket corner and peeled off old gasket. Snapped new gasket into door channel and made sure all the edges were seated. Took longer to open the shipping package than to do the repair.

Defros timer was easy I finished it in about 15 minuts but the defrost themostat was hard.I had ploblems with the wire conectors and the tape I had to use Twist-on wire connectors.I hope I will not have problems later.So far 1 week later it is working.I can't belive $50 saves me $600.Thanks to Part Select for the video and how fast they shipping my parts in less than 2 days.

Not long after we bought this fridge, the plastic on the light switch cracked, making the lever stick out too much so that the door wouldn't close. It's been taped down ever since. I simply pulled the old switch out and plugged the new one in. I'm kicking myself that I didn't do this ages ago. It was so easy and now I can see inside my refrigerator again.

it was very simple , it just pressed right into place i was very impressed