WRS3R3EWB Crosley Refrigerator - Instructions

problem still persists part did not fix problem. made repairs recommended per your site.

Turned off the water supply ,pulled the plug removed two screws to access theater lines the new valve body was a little different than the original I had to cut off the end of each hose and push them in to the new connections the hoses are size and color coded replaced the two screws put the water line on plugged it in and turned on the water checked for leaks twice and replaced the back cover

After removing the lower section which just snapped out I went to remove the three screws on the bottom of the water/ice dispenser. The only problems I had we're here in that the screws were rusted and difficult to get out with water falling into this area over time. Then I easily removed the three screws holding the motor and actuator. Of course there was three more screws holding the water dispenser actuator in place. I took the broken piece out and put it all together again but placed some rust resistant screws I had to replace the three rusted screws. Works great!

service was great-got filter promptly- on line instructions very helpful. showed how to turn off water, remove filter and replace with new one. no problems.

Used needle nose pleirs to slide the old fan off.Then slide the new fan on the spindle.The video really made this easy!

order ice container and auger assembly

ice maker= replaced overload,microswitch and solenoid water valves.refrigerator=replaced the thermostat.Great price on parts,very fast delivery and parts were a perfect fit.You made the job very easy. John

Removed the ice maker cover on the front (6 screws)...took off old parts and installed new ones....very easy... replaced front cover and no more frost build up in the freezer.

Because of the design of the support, this could have been a difficult job. However, with the video that was provided when I selected the part, it was not a problem. All you have to do is knock the center pin through the support and remove the old support. Pull the pin out of the wall of the unit and push the new support in and drive the new pin in until it is flush. That's it!

Three very easy to get to 5/16" x 3/8" bolts to remove cover and mount. Elbows were tooless push to release type. Elbows removed in seconds from old housing. Elbows simply pushed on to nipples of new housing. Same three bolts to remount and done!

It was so easy, i did it myself, also the help of a you tube video from Partselect. I was so proud of myself even though it only too less than 15 minutes to fix. Now no more wet towels laying around. thanks so much for your help.

Ordering replacement parts was easy! Expected a simple pull out old plug, insert new plug.... Not sure if it comes from factory like this or if this had been previously repaired poorly, but the broken plug was heavily glued in place. Took some serious finess work to remove without serious damage. Once out, it was simple plug in

Repair as illustrated was right on. Repair was easy. No problem except still no water for ice or drinking. The valve was not the problem. Filter was replaced prior to valve replacement. Must be a electric switch some where. 3 Yrs ago I have replaced the water activation plastic lever for drinking which was a bit difficult and it turned out ok.

Initially ordered the wrong frame. PartSelect almost immediately replaced it with the correct part and made the return of the incorrect part quite easy. No tool necessary, a sanp to replace, and now we have an almost new fridge again. Thank you!

switch out perfect fit