WRS26MZRHD1 Westinghouse Refrigerator - Instructions

After receiving the replacement drawer from PartSelect, I removed the broken drawer and took off the front (since the drawer is sold separately). It came off easily with a putty knife. I cleaned the front (clean every 10 years whether it needs it or not), slid it onto the drawer, used the putty knife to reattach the lip and slid the drawer into place. Took ~3 minutes. There is a very good short video at the website if you are unsure about removing & attaching the front piece.

Initially I changed the filter, but in so doing, I misplaced the o ring located in the filter cup; without that o ring water leaks out every time it cycles. I purchased the o ring online (five dollars plus eight dollars to ship) and bingo no more leaks.

Removed the timer, installed the new one. Great service from part select

Followed the sites instructions. Empty the bottom part of the freezer. Remove the screws. Move the panel out of the way. Easily remove the old part and replace with the new. Put the panel and screws back in place. The freezer works.

Simply turned off ice maker, carefully pulled the old assembly straight out, slid the new assembly in place, making sure the motor connection was correct...DONE!

moved freezer items to right of icemaker,loosen two nuts lifted icemaker over nuts,squeezed and pulled cable out turned over marked L bracket screw with marker for location plugged cable in tighten screws,made ice in 2 1/2 hours john

replaced the defrosting timer and saved a lot of $ by doing it my self.

Rail was very easy to unscrew and put new one on. Just 2 screws. The crisper drawer side was cracked so I removed the clear front piece and slipped it onto the new one.

1st my 72 year old husband has not had great success in repairing anything: electrical or plumbing. We got the part the next day. Had ordered it late one afternoon and had it the next morning in Wyoming. From the time we took it out of the box, disconnected the old one, plugged in the new one, remounted, it took less than 15 minutes. Amazing and it works great. Didn't need extra electrical connector, but tricky part on electrical connectors is to squeeze side to take apart and put back together. He used mirror to see the screws to loosen to take out and put back in ice maker. Next day our tray was full of ice. Good service/Good Product.

First I watched the repair video on this site, then I ordered the part and did exactly as the video said, and it was very easy. Went smooth as silk. Thanks.

remove the old tank, connected the fitting into the hose,turned the water on and we had ice and cold water again.

tool front facade off and slid onto new drawer(part).

Took off the old crisper drawer cover supports with the screw driver and put the new ones with the screw driver and small hammer (really easy)thank you to your installation instructions video.

pulled out freezer, went to floor,reached in next to compressor pulled off clip just like on the video.Pulled off old capacitator took off wire leads.Installed new one. Freezer runs great.Loaded it up with beef pork and venison. No problems.

First off make sure you have a good quality Phillips screw driver. When the blade is worn out you can disassemble the ice maker with out removing the front. But to reassemble the front cover must be removed. Do yourself a favor and buy the drum and nut also. I am a mechanic by trade so the tools and repair was really easy. Be careful of the ice crusher BLADES they are very sharp. If your not mechanically inclined take pictures before disassembly, that will help you greatly. Hope this helps someone. Thanks Rory