WRS23W0AW6 Westinghouse Refrigerator - Instructions

I followed a video I found on how to take the front off of the ice dispenser ( to me the hardest part) Once I was in there it was a matter of removing the pin and spring,then putting the new flapper in place of the old. Hardest part in reassembling was getting the spring back where it belongs. After that it was a matter of putting the ice dispenser back together and testing. Works perfectly.

Replaced ice maker - easy to replace but it did not fix the problem.

Remove 4 screws to get the housing cover off. Remove the lock ring that holds the ice auger in place. REmove 4 screws to get the crusher housing off. Reverse the order to replace the housing. Very simple.

Your video tutorial was great just did what it said to do. Your service in mailing parts was awesome. Thanks so much!

Had a little trouble getting old pin out of support bracket finally used screwdriver and broke plastic so I could get to the pin and used needle nose pliers to remove hanger then came right out putting new one in was a snap slid in tapped pin in and installed new crisper bracket took about 15to 20 minutes to complete.Contribute difficulty in removing pin to age of refrigerator had been in place for at least 5 years maybe longer overall experience not bad.I am 75 would probably been easier for a younger man more flexible.

first replaced dual solenoid, then ice maker. still not working. going to chase electrical next

It went okay. My husband did the job and he is handy. We both watched the little "How to" video and that was very helpful.

It was so easy the light socket came right out took out old undid clips (light was melted to socket)put new socket piece in reattached clips...light works...as far as the door not closing...unscrewed on screw took off plastic clip put it in and put the hinge bearing on top...put refrigerator door back on...first top then squeeze bottom on...I bet I saved over $150.00 dollars if I called a repair man for a 15 minute job...your website made the job alot easier discribing what the problem was and parts need...easy to follow....thank you

I removed the top hinge cover, loosened the hinge so I could remove the door and laid the door on it's side. I removed what was left of the Door Closing Bearing and istalled the new parts. Set the bottom of the door on the lower hinge then postioned and set the top hinge into place and tightened the top hinge and installed the hinge cap.

removed cover from top hinge,then hinge r&r bottom cam plate reinstalled door. now no noise opening door,ice naker is very simple turned water off to frig loosened two screws and unpluged wiring.harness is a little long. took a while to make ice next morning it was working fine

It was simple... After paying $280 for a repair man to come out and install some unnecessary part to the fridge when I told him "everything on the Internet points to a thermostat repair." He disagreed, fixed the fridge and said the freezer would work more efficiently now. It didn't, so I bought a new fridge/freezer, put the old one in the basement. I ordered the thermostat (under $20), put it in, and now (knock on wood), works great and I have a beer fridge for the man cave

Ordered the part online and it came the next day. No problem putting in the new bin; it took less than a minute and no tools required.

Just removed the glass and popped the plastic piece out. The new part fit perfectly. This part came overnight...awesome service, exactly right part, easy to find. Would definitely use them again.

The replacement was simple, only two screws and the electrical plug. The problem was the location of the two screws that were impossible to see directly and difficult to access with a screw driver.

I watched the step-by-step installation video and followed the instructions therein.