WRS23W0AQ4 Westinghouse Refrigerator - Instructions

Replacement took about 10 seconds, just put it onto the holding brackets, pressed down and presto...DONE!

I removed the door and replaced the broken hinge bearing with the new part and the door works great!

According to the online video instructions.

it was a simple fix, all i had to do was remove 3 small bolts from top of door, set door aside remove 1 screw that holds door cam in place, install new door cam.hole job took about 15 minute's.

Couldn't have been an easier. Removed the screw/nuts from the top of the fridge door that held the door in place and removed the door. Unscrewed the holder at the bottom, replaced both parts and put the door back together. It took me longer to get everything out of the fridge door than to replace the parts. EASY AS COULD BE!!!

I basically took the two shelves and in stalled them.

Took the door off,as per instructions,pulled the worn bottom bearing out, pushed new in and replaced door. The job was very simple and took about ten minutes. Also I received the part in two days after ording

put in a new one

I watched the video and did the same thing on mine and now it is working fine

Simply removed two screws from top hinge and lifted door off bottom hinge. Next leaned door over and removed broken portion of bearing. Finally reinstalled door and works like a charm. Thanks too this site painless repair. Oh ya part is a perfect fit.


Thanks Clay


P.S. Would recommend to a friend. Note shipping WOW. Please consider using US Mail. Shipping more than part. OUCH.

1-Remove upper plate with phillips screw driver (6) screws 2- remove upper hinge plate with ratchet and socket (2) bolts 3- lift door off bottom cam, lay door flat on floor. 4- Remove broken cam on lower part of door, just pull out. 5- Install new cam in bottom of door 6- raise door up, set on cam, reinstall top bolts and screws 7- p. S. Make sure you trace top hinge location with a pencil before removal, so installation has proper location.

Unscrewed top part of door,put it down and replaced hinge bearing,apply some grease,put door back and done very easy do it yourself.

I removed the top door hinge, and then lifted the door off the bottom hinge. The bushing which helps close the door was completely worn away. I pulled out the left-over bushing parts, installed the new bushing I had ordered fro you, and reinstalled the door. It works perfectly now.

I followed the website instructions, step by step. The web instructions were great. Easy to understand. Complete. Do yourself a favor.... just follow the instructions off the web! Great service! I am so happy to have found Part Select and will recommend to my friends.

Ordered the part from PartSelect. Estimated time for slow delivery seven days. I got it in three. Removed the cover from the water and ice maker dispenser arena held on by three screes. I had to use an easy out on one rusted scree. Disconnected the wiring to the switches and lat the Circuit Board come forward by removing three small screws. Using tweezers to catch the screws, I removed two small screws holding the broken actuator and put the new one in its place making sure the spring was properly located and the ice maker swivel was under the hold-down strip along with the new actuator. I reassembled the door cover and got a drink of cold water. By the way, always unplug the refrigerator because that area is hot. Dr Robert E McGinnis author of In Search Of Paradise and many other fine books found on Amazon.