WRS23MW3AQ3 Westinghouse Refrigerator - Instructions

The old pins have to be completely dislodged (preferably with an awl) before placing the new crisper support. The new pin of the support should be driven easily into the hole on the refrigerator´s wall with a conventional hammer (carpenter type). If you find resistance while hammering on the pin, do not continue. This probably means that the old pin is still inside the hole and does not allow the new pin to go in.

I followed the website instructions, step by step. The web instructions were great. Easy to understand. Complete. Do yourself a favor.... just follow the instructions off the web! Great service! I am so happy to have found Part Select and will recommend to my friends.

took door off ,replaced the hinge,and put door back on....

After taking door off, I found the door closure/hinge bearing was broke. I got manual out, looked up part number, googled it, and ordered the part from this website. Couldn't be happier!! My wife is really happy too, such an easy fix

put in a new one

I watched the video and did the same thing on mine and now it is working fine

I needed one with the adapter. I installed it and there was ice in the tray the next morning...no problem

Drove pins all the way thru supports & then pryed support off. Tapped new supports in place. Watch the vidio on installing new supports. I probably wouldn't have been able to get the supports off without the trick I learned to just knock them on thru. Took all of 5 minutes to replace 4 supports.

Replacement took about 10 seconds, just put it onto the holding brackets, pressed down and presto...DONE!

Due to the nature of the support deisign and installation which was unusual I watched the video on how to extract the old broken support and install the new one, odering the new part was simple as the view privided in the parts section was specific and and easy choice to make, cost was very minimal and I received it the next day due to my being in close proximity to the shipping point, thank you and my crisper is very happy and so am I.

Removed the top hinge pin and lifted the door off the bottom pin. Removed and replaced the bottom defective parts and reinstalled the door. Reinstalled the top hinge pin which completed the project.

I removed the door and replaced the broken hinge bearing with the new part and the door works great!

According to the online video instructions.

it was a simple fix, all i had to do was remove 3 small bolts from top of door, set door aside remove 1 screw that holds door cam in place, install new door cam.hole job took about 15 minute's.

Couldn't have been an easier. Removed the screw/nuts from the top of the fridge door that held the door in place and removed the door. Unscrewed the holder at the bottom, replaced both parts and put the door back together. It took me longer to get everything out of the fridge door than to replace the parts. EASY AS COULD BE!!!