WRS23MF5ASD Westinghouse Refrigerator - Instructions

Once the part arrived, we followed directions to remove the refrigerator door. We removed the hinge cover which was a two-piece topping on the refrigerator. We then were able to remove the door and replace the lower Hinge Bearing. We put the door back on, replaced the cover and the door now opens and closes quietly and smoothly. We are senior citizens and not particularly "handy"....figured we saved ourselves $100. or so. Good deal.

Ordering replacement parts was easy! Expected a simple pull out old plug, insert new plug.... Not sure if it comes from factory like this or if this had been previously repaired poorly, but the broken plug was heavily glued in place. Took some serious finess work to remove without serious damage. Once out, it was simple plug in

After the original hinge fell apart, I clicked on my bookmarked Part Select www. I simply typed in the model number and followed the instruction straight to a Parts diagram. Both parts I needed were detailed in a scale picture, and were extremely easy to purchase. Partselect is the best appliance part service online, I repair all of my own appliances and save hundreds of dollars on repairs by using the reliable Partselect ordering system. PARTSELECT HAS NEVER LET ME DOWN!!!

Repair as illustrated was right on. Repair was easy. No problem except still no water for ice or drinking. The valve was not the problem. Filter was replaced prior to valve replacement. Must be a electric switch some where. 3 Yrs ago I have replaced the water activation plastic lever for drinking which was a bit difficult and it turned out ok.

Initially ordered the wrong frame. PartSelect almost immediately replaced it with the correct part and made the return of the incorrect part quite easy. No tool necessary, a sanp to replace, and now we have an almost new fridge again. Thank you!

switch out perfect fit

Pryed the old loose catch is on the bottom used a common screw driver.pulled the two wires off reversed the procedeure to put the new switch in.took about 5 minutes.

Installed new support. I placed the new one in the hole provided and taped in the locking peg with a small hammer. The total installation took about three minutes thanks to the excellent video provided on the web site. Thanks

The water flow on or refrigerator was just trickling out. After trying to make sure there was no kink in hose, I called for replacement. Water flows great now... actually better than when new.

This is a very simple and straight forward repair. Remove the outer cover held by 3 screws on the bottom of the dispenser. Then remove 3 screws at the top of the dispensing unit. You are able to lean the dispensing unit far enough out from the top to remove 2 screws that hold the actuator in. Remove and replace the actuator, screws, and dispenser. Easy fix.

replace the control panel and harness

I was happy you all had the part that I needed and I could easily remove the old one and slide the new one right into place!

Removed old fan motor and installed new one.Not much room for big hands back there.Flexible extensions valuable on this job.

The installation you tube instructions that were sent with shipping confirmation were excellent! Watched it once and the repair was done with ease!

I was worried that the support was a permanent fixture in the refrigerator wall. But I pried it out and replaced it with the new part. Holes were exactly the same size so the new part easily replaced the old one.