WHDSR316G0WW General Electric Washer - Instructions

took 4 screws off top of control panel, lifted it out, pulled off control knob, removed 2 electric wires ( unit was UNPLUGED )lifted up / pried up metal tab, turned counterclockwise 1/4 turn , removed plastic hose and walla ! reversed to installed. a piece of cake, less than a two beer job ! p.s, you tube has video's of this and helped alot. very very easy. now i'am taking down my kenmore elete he3t washer ( made in MEXICO of course ) for outer tub bearings. everything has to come out but i can do it ! woot woot !! and a special thanks to PartSelect for having the correct part.

remove top panel, replace the compression clip, then replace'd the top panel, w/pliers, remove'd then plastic clip from the timer knob, remove old knob, install new one, DONE! I've never had a place that had all parts in stock, and at my door with-in 2 days! UN-BELEIVABLE! THANKS

I removed the plastic pin, took the knob off, put the new one on, then replaced the plastic pin. EXTREMELY easy.

order part. replace

I watched the video you provided and I could't believe how simple it was. I'm 67 yrs old and I just followed the video instructions.

Use a flat head screw drive to push the clip off the timer stem which holds the knob, which is behind the knob, pulled old knob off, place new knob on timer stem, used needle nose pliers to push new clip on timer stem to hold knob on

I used the piler to take off the old knob then install the new one.

I went on Utube and watched a video. Explains exactly what you have to do. A real skinny pair of electrical pliers helps to get the plastic pin out. The replacement knob comes with a new pin. This repair actually does take less than 15 minutes.

First I removed the softener dispenser then I grabbed the agitator at the bottom and with a tug completely removed it. I took the new part out of the box and lowered it down over the hub in the bottom of the washer and gently pushed it until it snapped in place. Then I re-installed the old fabric softener dispenser and the job was complete.

I removed the clip with needle nose pliers pulled the knob off,put the new knob on and replaced the clip.

I laid the washer on its front and removed enough screws to fold the bottom out enough to reach it. I used a wire tie to secure the belt to main pulley and slipped it on the drive. This would have been nearly impossible without the install tool as it stopped the belt from slipping off of the drive. It was simple to turn the pulley clockwise to walk the belt onto it. The whole repair took about 1/2 hour, would have been less if I had used the wire tie at the very beginning.

After ordering the part on a Friday afternoon, I was amazed to have it delivered before 2PM the next day. The part was the timer knob and it was a perfect fit. It took less than 15 minutes to replace the faulty knob with the brand new one. Amazing!!!

Unplug appliance. Use needle nosed pliers to remove clip from behind the knob. Remove knob and replace with new knob. Push in to install the new knob until you hear the "click." There you have it. Easy. Another task completed from the "Honey-Do" list.

worked liked a charm thankyou

I took the pliers pulled the plastic clip off the back of the knob and pulled the knob off the dial lifted the dial off. I pushed the new dial on then pushed the new knob on and I was done. The hardest thing was to open the plastic bags the parts came in. The next time I will use a knife or something else to open the bags