WHDRR418G1WW General Electric Washer - Instructions

Turned off all power. . . Took top back off. . . Retored starter back in position. . . Attached knob. . . Replaced back, turned on power. . . And thanks to utbe instructions

I took off a couple of screws on the back of the control panel and took off the front of it. I removed a couple of screws from the part and the two electric connectors. Then I removed the part and placed in the replacement, and put back the connectors and screws. Now the machine works great!

Watched the video you had on how to replace it and did it like you showed and said and it worked fine.

folloe inst. provide on ge sight

I used the piler to take off the old knob then install the new one.

Pulled out washer undid control panel, disconnected timer. Replaced timer reconnected harness and replaced control panel. I had a brief moment of panic when I realised both parts looked identical and that maybe I had put the original back in, but this was not the case, when I ran a wash through the machine. I would suggest that one puts a date or some mark on the new part.

First I removed the softener dispenser then I grabbed the agitator at the bottom and with a tug completely removed it. I took the new part out of the box and lowered it down over the hub in the bottom of the washer and gently pushed it until it snapped in place. Then I re-installed the old fabric softener dispenser and the job was complete.

I laid the washer on its front and removed enough screws to fold the bottom out enough to reach it. I used a wire tie to secure the belt to main pulley and slipped it on the drive. This would have been nearly impossible without the install tool as it stopped the belt from slipping off of the drive. It was simple to turn the pulley clockwise to walk the belt onto it. The whole repair took about 1/2 hour, would have been less if I had used the wire tie at the very beginning.

I took the pliers pulled the plastic clip off the back of the knob and pulled the knob off the dial lifted the dial off. I pushed the new dial on then pushed the new knob on and I was done. The hardest thing was to open the plastic bags the parts came in. The next time I will use a knife or something else to open the bags

opened the front control panel, took out bad, vale, replaced it with new valve, closed panel.

With the instructions found online, this was a quick easy repair. I used youtube to have video to show the method. Used rope to pull up agitator, used wrench to loosen bolt and then put back together. Part was delivered really fast, I recommend Partselect.com for the parts you need!

needle nose pliers to pull out old tab behind old knob. simply pop new knob on when you remove old. video gave me self confidence to do it myself.

Pulled clip off and installed new knob

1. Turned off water at wall and removed hoses from back of washer. 2.Removed three screws and laid dash panel forward onto towel. 3. Used pliers to slip hose clamp off of valve connector. 4. Disconnected two electrical connectors. 5. Removed two screws mounting inlet valve to washer and removed valve. 6. Reinstalled in reverse order. My only problem was a vibrating noise when hot water was selected. I found that the fit of the dash panel to the back of washer was torqued. I removed the panel mounting screws, made a better fit and added a dot of rubber insulation between the sheet metal parts where the screws attached. Success!!