S1070A5WW General Electric Washer - Instructions

I found the diagram in your website, identify the problem, order the replacement part and replace it in 10 minutes. Great deal, thanks.

Watch how to fix it on You Tube. Order the part I needed and fixed. Real simple. That is it.

KNob has gears that mesh with the washer. Simply put on the post and slid the clip into the groves on the stem. Pushed it on with needle-nosed pliers.

I pulled the top of the agitator off (the softener dispenser) then pulled the agitator itself off. I had to pull with some force. I used the socket wrench to remove the bolt on top of the agitator coupling. I then pulled off the old agitator coupling, replaced it with the new part. Used the socket wrench to tighten the new bolt. Lined up the slots on the new coupling with the agitator top, it slid on with a little resistance. The last part to replace was the softener dispencer.

Gently turned washer over onto its front. Removed bottom metal panel (3 or 4 screws on each side). Removed old belt. Installed new belt. NOTE: The new belt is a tight and perfect fit, therefore it will not want fit on to both pulleys/ rotating discs. I have found the best method is to start the belt on the disc that drives the belt. Then place as much of the belt over the disc that sits below the washing machine drum as is possible(the spinning part)and then turn the belt by hand and the belt should pop on to the disc. If the belt goes on easily you may have the wrong belt as the belt must be tight to achieve the traction necessary for the washing machine to spin. HOPE THIS HELPS!! A screwdriver may be handy in helping to pry on the belt. Good look.

replaced the dual water inlet valve

I unplugged the washer from the outlet. I pulled out the timer knob and used needle nose pliers to remove the clip from the rear of the knob. I removed the old knob and inspected it. Sure enough, the teeth that engage the timer were worn down to the point where they no longer would engage and turn the timer. I installed the new knob and ghen installed the new clip to secure it to the timer. I plugged the power cord in and tested the washer.....done deal!!!! Parts Select made this job easy and saved me a lot of money by not having to call a service company. The part arrived in two days, it was the exact replacement part, it was good quality. I will do business with them the next time I need to repair an appliance. Great service, great web site.

watched your video fixed it in a heartbeat I like the site very much also, I looked up the part in a minimum amount of time.I would say it took me 3 minutes total ordering and replacing Loring Gantner

order part. replace

I watched the video you provided and I could't believe how simple it was. I'm 67 yrs old and I just followed the video instructions.

I used the video instructions sent to my email and everything worked perfectly as instructed.

My 45 year old son did it in the shop, and it only took a short time before we were washing clothers again, and no water on the floor. The part came through the day after I ordered them. Thank you very much

Remove agitator remove retainer screw and using Prybar lift off the old coupler ..... After removal use heat gun and wire brush to remove plastic residue from the splines of the motor shaft ... While the shaft is still warm line up the splines from the new coupler and using the mallet force the coupler on the shaft ... Install the retainer screw that comes with the coupler and snap on the agitator ... Done

Opened the package - put it on just like the old one. Didn't take 5 minutes. Good as new.

I pulled up on the fin part of the agitator exposing the gear coupling. I unbolted the nut on top with a 12 mm socket. Once the nut and washer were removed I pulled up on the gear coupling and slid it right off. Reversed procedures to install the new one.