RS22BRXDN01 Roper Refrigerator - Instructions

Took it out and slipped the new one in.

Disconnect power. Remove back panel on the refrigerator. Relay and overload is a modular unit attached to the compressor. Disconnect module from compressor, install new unit. While you're in there clean the condenser coils with a vacuum and clean the fan and condensate pan. Reassemble, and you're chillin. Total time approx. 15 min.

Unplug the unit cord, remove 3 screws on the icemaker. Unhook the wiring harness from the refrigerator, remove the unit and reverse the order to install the new unit. Reinstall the on off bail, and the icemaker tray. Make sure that the unit is level after the new installation so that water does not spill out of the icemaker.

R and R parts

Removed the broken icemaker per instructions provided with the replacement part purchased. by Part Select. The whole procedure went very well and my new icemaker is working like a charm. I highly .recommend Part Select. Kitchenaid had discontinued making the the original icemaker and Part Select provide an OEM replacement that worked perfectly.

just like video very easy ! Thank you for the fast service and good information for installation.

I ordered both the defrost timer and thermostat thinking the problem was the thermostat but scince the two parts were housed in the same part of the refrigerator I decided to replace both parts. Watching the YouTube video made this job a complete success!! The parts arrived within 24 hours! This girl is a VERY happy customer. Thank you!

just remove the damaged one and replace with the new one---easy- breezy

Just re-intall the new drawer. That's it. Thank you !!

Followed recommendations from others but went with most likely by percentage = defrost timer kit. Did not solve issue. Then went with bi-metal thermostat and that did not fix the problem. Tested the thermostat as recommended on line and old part was bad, new part ok. Then I saw on line that I should have listened for fan operation. I checked and found the fan motor to be defective. Replaced the motor and refrigerator worked fine. Both the motor and bi-metal thermostat were required. Should have checked fan operation first.

Followed the instructions on package, went extremely well, with no problems what so ever! Thanks so much for the part and how to do list!

Searched internet until I found a company(yours) with the part needed. Could not locate locally refrigerator too old. After finding"Part Select" site I watched the video provided. It was very instructive and helpful. I cancelled calling any repair service and did the repair myself. The part was delivered fast and I had no problems with the repair. Your confirmation e-mail of part being shipped again provided the video for the repair. I only watched again after the repair to check myself, all went well. My Ice maker is working great again and I consider this purchase money well spent. I was considering another refrigerator but will now keep the Kitchen aid longer, Thank you.

This was not a through the door unit. The water dispenser is located inside the refrigerator. Unplug the refrigerator. Remove the two screws holding the cover over the dispenser parts. Could not remove the cover completely as there is a water supply line attached. Let the front of the cover down as far as you can get it. The micro switch is reachable. Move plastic retaining posts holding the switch in place, to the side to release the switch. This can be done with your fingers. Pop the switch out. Use the blade of the screw driver to gently pry the electrical connection plug away from the switch. Attach the new switch to the plug and put everything back in the reverse order of disassembly. Done, easy, even I could do it.

Just removed old ice maker which took about 2 minutes. installed new ice maker in about two minutes. Simple and easy install.

Debugged problem according to debug video; ordered part based on most likely part failure; part came in < 2 days; installed part based on installation video. Freezer and fridge both fixed.