RS22BRXBL01 Roper Refrigerator - Instructions

Easy.... Video made replacment very smooth. I only needed one tool a nuy driver.

I saw a video of it, and simply took apart the ice maker and put the new Auger Drum in, then reassembled the ice maker.

The repair was easy. I wish I would have had a nutdriver; that would have made it extremely easy and a lot faster. I used a small wrench to take out the old ice maker. The new one went in easy. The arm was easy to move from the old ice maker to the new one, but it was a bit snug. We had to manually push the arm down a few times for the icemaker to dump the ice. After about 5 batches or so, it began to work on its own and now we have a full tub of ice (for the first time in two years). This was certainly time and money well-spent. Any one can do it!

removed condenser fan -located behind refrigerator next to compressor, Not much clearance to work, there are 3 screws to remove from condensing motor,sounds easy but clearance is lacking to remove them ,(takes alot of PATIENCE). Then you have to remove the fan blades to be able to get clearance to remove motor!! I wouldn't reccommend trying this repair unless you are a pro.

One day the ice cream in the freezer seemed mushy, but the ice was still frozen. There was not water in the ice bin. However, the problem resolved itself. This suggested that the defrost timer had become stuck for an extended time, but then continued to run. The fact that the freezer went back to frozen, implies that all the components of the cooling loop (compressor, condenser & fan, evaporator & fan) were fine. It was possible that the problem was caused by a bad defrost (?evaporator?) thermostat but everything I saw on line suggested that the defrost timer is the culprit about 40 - 50% of the time. Anyway, I followed the instructions in the on-line video at this site for replacing the defrost timer and it was easy. It would have only taken 15 minutes, but I spent a while reading the defrost timer instructions and hunting down a schematic for my refrigerator, to determine which pin the loose wire should go on.

The ice maker installation video was a life saver. Thank you. Followed video instructions and removal of old unit and installation of new unit took almost no time. Again thank you for the excellent video.

First of all, I am a female. So anyone can do this.I simple watched your video. Made the repair very simple. I was surprised that it really worked. I couldn't understand that if the door would still eject ice, why it wouldn't make the ice. It's the same motor. Anyway, It worked and I thank you very much. Very satisfied.

With brief instuctions it was very sraight forward. Three scews hold the motor assembly on. Ordered on a Sunday and the part was here the following Tues. Thanks Partselect

I removed the old broken shelves and replaced the ends that were damaged. It took about 5-10 min.

Unplug refrigerator.loosen 2 screws,take bottom screw out.Unplug electric connector,take off ice arm,install on new ice maker.Reinstall maker.plug in refrigerator.Really easy to install!

Extremely simple especially after watching the video. Makes me think about why I did not attempt my own appliance repairs in the past. Big time savings! Thanks. P. S. excellent delivery service from Parts Select.

replaceed control motor assembly 3 screws took it off. then turned ice maker shaft by hand to line up key slot on new control unit . slid right together .ice started making within an hour . and the part got to my house the very next day after ordering awesome...

I watched the video so I had an idea of what to do. It was pretty straightforward. Turn off the water, take out the screws, line everything up, replace the part. It went smoothly and the icemaker is working again. :)

I followed instructions in the video you provided. No problem at all. Took less than an hour.

Just looked at your video twice and then did it with no problems. Thanks