RKS394 Caloric Microwave Oven Combo - Instructions

removed the shield and removed the old tube. Replaced with the new tube and replaced the shield. The only place I could locate this tube was through the internet. This Co. had as good a price including shipping that I found.

1. Unscrewed glass cover on bulb
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

ordered new broiler pan

My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.

very easy

Screwed in light bulb and glass protector

I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.

This is a simple replacement. The hardest part was that I had to shorten the seal because it comes 15 to 17 inches. So it needed to be shortened to properly fit. I cut the seal to fit, then took the metal hook on the end and super glued it to the cut end. I put a weight on it to make sure

First I removed the top vent, this exposed the control panel holding screw - I removed this screw lifted to unhooked and I swing the panel to the left - disconnect the harness attached to this panel and be able to removed it out of the way, then I removed a fan assembly located on the back of the cavity -- this exposed the capacitor - carefully disconnect the capacitor ( I was a little concern about this because is a high voltage cap) I used isolating pliers, just in case energy was stored, that's it. Put everything back and microwave start working again. I think I still need to find out why the fan is not automatically start running after I start the microwave and the internal light only goes on sometimes when I open the door - can anybody help on this?

After too many years of trying to make do with worn out burner bowls, I finally searched on line for Caloric replacement parts. My order arrived THE NEXT DAY(!!!)and make my old range look almost new! They are so shiny and clean, and fit perfectly. I am so pleased, and wish I had ordered from PartSelect years ago! Thank you for your speedy service!

Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.