RB757BC4WH Hotpoint Range - Instructions

Watched video,and used it as guideline.Biggest problem was removing tape from old wires.

First I shut off the breakers. I cut the wire from the end of the new part and took off the plastic off because the end of the new wire has a special end clamp to connect to the old wire which is in the stove but that wire didn't have the same clamp to be able to connect them together therefore I needed to cut the wire to from the new part also and connect it to the old wire with a wire nut which is on the range which is attached to all the other burners. Twisted them together and I put a wire nut to hold them strong together, pushed in the end of the burner into the 2 holes of this new part. I turned on the breakers.

The only tool needed was a nutdriver to remove the lamp socket. I needed my head mounted light to see what I was doing, and everything went smoothly from there. Simple job.

as described on video,with no problems,very helpful

The part was just like the old one and would have been an easy fix except our range suffered from a lighting hit. The clips had melted together. Called a dealer and asked about a new wiring harness. He said in those cases just cut the clip off and hard wire with wire clips,or firecrackers. We used wire nuts and taped all together and the oven works just great. Nothing is ever as easy as it should be.

Disconnected the plug from the receptacle; removed the 2 screws holding the element in place at the rear of the oven; removed the support bracket at the front (also 2 screws); removed the panel on the back of the range; pulled the wire clips off the element (had to replace one of them); slid the new element in place; reconnected the wires and fastened the element in place; reattached the support bracket and rear panel ... With the assistance of my wife (extra hands) this was an easy job!

unplugged old block from both sides, ran new wire and plugged new wire to both ends and presto it worked, thanks for making it easy to fix. Thanks- Michael J Dumas

I removed the old burner and replaced the new burner and bowls. Works fine now.

Followed the excellent videos from partselect.com. I would just add the following caveat for the Bake Element process: When removing the electrical leads from the old element tie a string to the lead before removing them. The wires were a bit tight on my unit, and when I released the first lead it sprung inside the firewall (probably not the right word for it). I tried snaking it out to no avail, and had to remove the back panel to get to the lead. Other than that it was easy as pie with the video instructions.

Parts arrived in record time and the right parts. The detailed diagram was so helpful in finding exactly the part I needed to order. Was so easy my girlfriend with no mechanical or electrical experience completely helped me through the entire project. She secured the electrical breaker to the range, and I had the top back to the oven removed. I showed her how the little white box simply slides off the lens cover, then replaced the new one in the holes and slide it back on. Secured the back and she turned on the breaker back on...and all lights work. Thanks for making this project easy, simple and quick.

Replace the sucket for the heating element.

Exactly followed the instructional video and my installation was flawless. Now the burners power up and function like new. The whole repair was smooth and easy.

The hardest part of the repair was moving the stove away from the cabinets to unplug the electricity supply. I have a 1/4 socket set that I use to remove the socket head screws that hold the cover on the back of the stove thus accessing the terminals for the burner. Fishing the wires back to the terminal was a effort as the the stove cover does not hinge open enough to allow easy access. The time to make the repair was, guessimate, 10 minutes which includes moving the stove out and back into place.

Replaced all terminal blocks per your instructions and replaced old bowls. One 8" bowl did not fit flat on the range top which I reported to your customer service.

This installation was for a replacement for one of the burner bowls on the original order. Replacement bowl fits proiperly.