Enter the code DIYDAD10 at checkout to apply your discount. Discount will be applied at checkout when the code is entered & applies to all parts. Cannot be combined with any other coupon or special offer & cannot be applied to a previously placed order. Not valid toward tax or shipping & handling. Discount has no cash value. Discount expires on June 17 at 11:59pm EST.
You've Got 10% Off Your First Order!Save 10% with code at checkout *click to copy coupon code
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
the bake element was burned into.
1. remove 2 screws holding element in place 2. unscrew the wires from the old element 3. the connectors on the new element was different from the old one 4. cut old connectors from wires 5. prepare wires for new connectors 6. install new connectors 7. connect the new element to the wires 8. replace the 2 screws removed in step 1 9. test the repair 10 it worked great.
First, I removed the 2 screws holding the element in place. Next, I pulled the element out abotu 4 inches and disconnected the wires attached to the element. I was able to do one by hand, but the other required needle nosed pliers. (be careful not to pinch the connecting wire). Then I attached the wires to the new element. Lastly, I replaced the 2 screws to hold the new element in place.
SUPER EASY! The part arrived very quickly. I turned off the circuit breaker, unscrewed the few nuts, pulled out the element and reversed the process. 'works beautifully! Thanks so much.
The broiler unit had disintegrated at both connections. I removed the two screws in the top of the oven holder the unit, pulled out the unit, measured and ordered a replacement.
To replace the element, I pulled out the stove, removed the rear panel, located the connections for the broiler unit, remove parts of the old unit. I then attached the new unit to the top of the oven with the two screws, went around back and pushed in the two connections, replaced the back cover and replace the stove. It took about 30 minutes because I cleaned everything and sprayed bug spay (another plus for doing the repair myself).
Well, when you put the back cover on and screw it down make sure you have nothing touching the white wire leading to the oven light. I did and it blew the push switch when I threw the 220 breaker. Actually, the light was on when I came in the room, but when I pushed the switch on the front panel it sparked in the rear and popped the breaker. Then I saw the short and when I tested the switch it would not click. The install was fine.
The original unit burned through and would not work, of course .
After unpacking and checking the unit that was mailed to me, I cleaned the ends of both the connections in the oven and the connections on the part, then plugged them together and screwed the plates in place in the oven. The oven worked immediately and still is working very efficiently. I had no problems at all with the installation.
Inspect new part; collect tools; TURN OFF BREAKER; remove two screws holding defective element (KEEP!); install new element using saved screws; turn power back on; test; celebrate!
Took two screws out of burned out unit. Pulled element forward and pulled off connectors. Replaced new element on connectors and screwed back in. Extremely simple. Less than 10 minutes.
I killed the circuit breaker to the oven, then double checked with an electrical tester. I removed the oven door for easy access, unscrewed the element bracket screws, plugged in the new element and then I reversed the steps above.
I am very happy with PartSelect and will use them in the future for all my appliance parts needs.
removed old burner. 2 screws. disconnected connectors and reconnected new burner screwed back in place. turned on stove worked first time. perfect fit. 15 minutes total repair time. item arrived promptly and at half the price of the Whirlpool website.