RAB4132AW1 Roper Washer - Instructions

found the how to on youtube, did it right in the laundry room, got it done in the morning before i went to work,

Your video made it easy, thanks

as per videos, replaced clutch. worked perfect. thanks so much. i will definitely will use your services again. joe

followed instructions on removing top and cabinet.unhooked the hoses. released the clips holding the pump. replaced the pump.put clips back. hooked up hoses. replaced cabinet and top.

Note that my washer is over 14 yrs old. With the video I was able to make the repair. However, due to the age of my washer, the repair was not a direct swap - there was one simple preliminary step in addition to the video instructions. This preliminary step was described by instructions received with the part. My advise: always read and follow written instuctions no matter how simple they appear to be - it will save you a lot of time.

I followed the instructions from your web site, and it was very easy. I started to purchase a new washer, but after watching the instructions I thought I would give it a shot. I am 67 and this was my first ever washing machine project. Thanks for your service and web site. If I need help or parts in the future, I know where to go. You saved me a lot of $$$.

Used video provided by your company for reference, went down stairs and replaced the parts. I replaced the motor just because of age as well as some of the above listed parts.

received along with my confirmation of order, a video and step by step instructions that I printed out. The installation went absolutely perfect. No stress, no mistakes. GREAT! Thank you

Since I had taken the washer apart before to find the problem, it was easier to remove the cabinet.Four screws and a electic connection. I remove the cabinet to get to the balance ring.I removed the tub ring by releaseing the catches and pried off the ring. Installation was just the reverse. Had some trouble putting the cabinet back whereit needs to be but once I got it the rest of the job was easy.

Follow your repair video, excellent.

Watched the video, followed steps shown, fixed machine. Easy piezy Japanesey.

Super easy repair for my 20 year old washer. I have a really small laundry room and was worried about how much of an ordeal this would be. I had just enough room to remove the housing and get to the motor assembly without putting the machine on its side. The repair was just as shown in the video; 2 clips for the pump, 2 screws and 2 more clips to separate the motor from the transmission. I installed the new coupling and was doing a load of clothes in less than 30 minutes. Great service, fast delivery and low price. I will be coming back to PartSelect for my next repair.

Started by unpluging and disconnected water hoses.Removed agitator retaining bolt and pulled off. Tipped machine onto a support on it`s front side. Unplugged motor connector and removed drain hoses from pump.Removed the three motor bolts and rotated and pulled out motor and shaft. Removed retaining clip and installed new clutch assembly. Plastic clutch drive looked ok but since it was apart removed retaing clip and changed it too. Slid shaft and motor assembly back into machine and reconnected everything,works like a new one.

After watching the video the repair looked easy. I took apart the unit per the video instruction, ordered the part and had the washing machine back up and running in 48 hours. Easy and the wife is happy!

Unplugged washer. Shut off hot and cold water. Pulled the washer away from the wall slightly to remove the hoses. Once disconnected I pulled the washer out further. Removed the two screws holding faceplate. Then popped the two tabs, allowing the tub cover to be removed. Disconnected the wire connector from the pins, and then removed the tub cover. I was then able to disconnect the water inlet valve. I replaced the water inlet valve, the internal hose and the two clamps. Then did the above in reverse order.