RAB4132AW1 Roper Washer - Instructions

Determined based on some Internet searches that the part that we needed was the motor coupling; washer would not spin or agitate. Once I figured out how to removed the cover (by the way, one of the guys at an appliance store told me how to do it), and reviewing the video on your website, I removed the two screws and four clips, dropped the motor, inserted the parts and put it back together - all in about 15 or 20 minutes. It was easy and clean and the washer worked again. Hopefully go for another 5-10 years. Thanks.

I found the impeller, in the water pump, had worn thru the front pump housing. Allowing water to leak on to floor. Replaced pump from under washer. Removed two hose's and two retaining brackets. Aligned pump and refastened hose's and retaining clamps. Works great. Thanks to Parts Select for the right part and the right price. Also Fast shipping. Dan H. Poplar Grove Il.

You have to determine if it is the COUPLING or the TRANSMISSION or the CLUTCH. I checked the coupling and that wasn't it. The machine did rotate back and forth in the wash cycle so I thought it would be either the clutch or the timer assembly. I ordered the clutch and used the video to guide me through the installation. One problem was the PUMP was stuck on the shaft so I removed the hosed and took out the rest as one unit. The clutch was full of crud and after replacing it and checking for leaks, the machine runs perfectly now! I would suggest you replace the hose washers when you reattach them to the machine as I rechecked after turning on the water and found a TINY drip that would have been a problem over time!

Friend of mine did it well

it was so easy to do. i just warch the instructions video clip from partselect.com

Followed the video, as simple as that..

Take off motor so the transmission comes out easier.You need to remove the agitator first.Took off old clutch and replaced it with all the parts that comes with the kit. Takes about 30-45 mins. Works great. The clutch didn't look like it was bad,but what a difference.

just followed the really simple installation video provided.REALLY SIMPLE...

Because the washer was over 5 yrs. old I took this opportunity to thoroughly clean the machine also. I took the cab.completely off including the back. I then removed the agitator,motor & pump as an assembly. I was shocked at the sledge that had built up at the top edge of the plastic tub. A thin brush and the water hose took care of that.Next I removed the old clutch & installed the new assem. reassembled the motor pump & cab. Ran the machine in the garage for a cycle to make sure it operated properly without any leaks before I hooked it up inside. I was impressed with the how to video it was a real confidence builder when undertaking this repair, also the price of the part was good and delivery was prompt. Parts Select has a new customer.

order the part got it in 5 days, and installed it 10 min. Just had to removed two clamps and two hoses. Saved alot on a repair men. Easy job to do

it was a little more of a problum I have the stackables . It was a little harder to lay them on there back . everthing great for me . But you need to send the directoins with the parts

Followed the steps on the Video that was post on the site. The repair was so easy I will keep this site in my bookmarked pages.

Website very helpful in visually locating and purchasing the part. Utube video also helpful. Took 30 minutes to disasemble and about 1 hour to reassemble. Works great! Biggest issue is laundry rooms are small spaces to work in and washer/dryer units are big! Thanks bill

removed clips holding water pump on , then removed 1/4 inch screws holding the clips holding the motor, removing the clips then. Replacing new coupling unit and reversing process.

My wife actually figured out the problem, ordered the part, which came quickly. I watched the video and fixed the problem. I'm sure this saved us a lot of money. Instead of a technician coming out and replacing the part for about $200, it cost us $25 and an hours work. Thanks. You'll be hearing from me for future repairs!