MWD36610 (MN03) Amana Microwave - Instructions

You had alerted that it was imperative to unplug unit before starting to remove defective bulb. As described, there was silicon on bulb and socket and bulb broke upon my attempt to remove. Had to use needle nose pliers to get metal base of old bulb from socket, then all went well.

First I removed the top vent, this exposed the control panel holding screw - I removed this screw lifted to unhooked and I swing the panel to the left - disconnect the harness attached to this panel and be able to removed it out of the way, then I removed a fan assembly located on the back of the cavity -- this exposed the capacitor - carefully disconnect the capacitor ( I was a little concern about this because is a high voltage cap) I used isolating pliers, just in case energy was stored, that's it. Put everything back and microwave start working again. I think I still need to find out why the fan is not automatically start running after I start the microwave and the internal light only goes on sometimes when I open the door - can anybody help on this?

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.

Removed the glass cover and replaced the bulb. Very simple.