MFI2569VEM10 Maytag Refrigerator - Instructions

removed the drawers and shelf. removed end cap with a socket replaced new part, reinstalled drawers and shelf. probably took 7 minutes start to finish.

The only challenge is: finding the correct replacement part for this model. Once that is done, the part just slides in, no tools needed.

The dispenser on the ice/water door mechanism has two trays with a metal one fitting inside a plastic one. I have put both in the dishwasher before but this time the plastic tray warped when I used the heat setting on the dishwasher. I was so upset. I found the part easily at Parts Select but I was not sure if the color was correct because Maytag has two different greys. The person taking my order was so helpful and sent me pictures of the piece on the computer as we talked on the phone. It was still hard to verify the color. Since only one of the greys was in stock, I decided to order it. The salesperson said that it would certainly match a stainless refrigerator. I did not pay for expedited shipping but I received the part in two days. How wonderful!!!! It took all of two seconds to install the part which matched my fridge perfectly. Thanks so much for the easy transaction and easy repair to my very expensive fridge.

It was easy, since I took the old one out, I knew what to do to put the new one in. Not problem, just a couple of screws!

Pushed it on.

Removed both drawers and glass shelf just above the drawers. Center rail just fit into place. Replaced glass shelf and both drawers. Took no more than 5 minutes.

The repair was very easy . . There was no tools required. The shelf rail just snapped in and out very easy

I replaced the broken part. There was one bolt to loosen with a nut driver. I disconnected the original wiring harness, reattached the new harness and reinstalled the hinges, which simply slide into place. Then I reinstalled the small bolt I had removed with the nut driver. The job was with no problems.

broke pins wed. morning ordered end caps wed. afternoon parts arrived next morning at 9:30 had it fixed by 11:30 30min repair time and i'mm 77years old. Out standing service. Removed veg. trays removed glass above deli tray removed broken pantry end caps installed new end caps two screws each.Very easy,took less than 30 min. Thanks

1.remove upper cold storage bins 2.rremove top glass on lower storage meat/cheese bin. 3.remove trim parts from front and rear 4. remove bin 5. remove trim pieces and slider mechanism from right side and back. 6. replace with new parts. 7. clean out gunk which accumulated on bottom of fridge. 8. reassemble in reverse order 9. Took longer than anticipated...over one hour.

Was a very tight fitting part and it had to be gently tapped into place.

Removed both veggie crisper and lower center crisper, removed glass shelves, removed broken side pantry end cap two screw, two were missing. Hardest part was to remove the rear adjustable piece and install on new end cap. Glad I took my time as the center rail will probably have to be replaced again. Poor design, numerous other comments say the same thing. Best part of the repair was ordering from partselect. Co, shipped on time and ordering was easy with complete parts diagrams.

Removed the drawers and glass. Removed two screws holding the end cap in place. Reversed process for new piece. Really really simple. Don't pay somebody else to do this.

biggest time was the cleaning of the area ;-) for the actual work it was less than 10 mins to replace. remove the three screws and there are two tabs on the back of the replacement part that you need to line up with the slots in the back and it simply snaps in place - put the screws back and you're done

I followed instructions provided by others on this page. I can't believe how easy it was.