MDB5600AWB Maytag Dishwasher - Instructions

received the new latch assembly quickly from part select.com, when you remove the screws on inside of the door, the old latch needs to be disconected from the wire harness, then replaced with new assembly and screws.10 minute job and it could not have been any easier to complete.

Just like you describe in the online instructions. Disconnected the power supply, removed door screws (torex),romoved electrical connections from old switch, installed them on new switch, aligned door screw holes, and reassembled. As a long time do-it yourselfer, this is one of the best experiences that I have had over the years. The part arrive by ground Fedex the day after I ordered it.As the MAN said "I'll be back" for my other appliance parts when needed.

I just removed the 11 screws around door and disconnected the wireing from the part after turning off the power. I then reconnected the wireing and returned the screws to the door turned on the power and it was fixed. thanks.

Shut off power to dishwasher, removed 11 screws inside door panel, unplugged the two wires, replaced door latch, plugged in wires, placed latch assemble back into the door, replaced the 11 screws. Turned power back on , tested dishwasher....... worked great.

ordered the part online per the diagram, the part shipped immediately, replaced part. Works perfectly, this is one of the easiest web orders we have ever dealt with. WOULD DEFINATELY RECOMMEND THIS SITE TO OTHERS!!!

Snapped new basket together and put it in dishwasher.

Take out 11 screws to remove door inside remove two wire plugsremove handle assembly plug in two plugs put back in place put inside door back on 11 screws done.all about 8min time

took off the interior and replaced the handle you get real good at this after a few times along with replacing the rack wheels the silverwear basket......

remove door panel cover and latch, replace door latch and replace door panel.very simple operation

Repair was simple. Simply removed the wiring connectors from old latch and plugged onto new one. Positioned switch in place on door and installed screws. Repair was simple and I received the latch the day after I ordered it.

Removing the cover and swapping the old part for the new with the directions from u made it so easy. . . .

East repair. Take screws out of door,pull out handle assemly, unplug (one connector broke, so glad I got entire assemly),plug in new one, put screwsback in, done.

1.Turned off the pwoer to the dishwasher.
2.Opened the dishwasher and removed the torx screws holding the back panel of the door. The top center two screw also hold the latch in place.
3.Gently opened the back cover about 4 inches.
4.Release the two small clips on each side of the latch switches. This releases the complete latch/switch assembly.
5.Remove the wires from the switches.(be sure to keep them seprated)
5.Replace the complete latch assembly with swithches.
6.Plug wires into swithes.
7.Replace rear cover.
8.Re-install torx screws.
9.Turn the power back on and your ready to go.

I followed the instructions and illustrations which were on your web site. They were excellent and it made the job easy.
Thanks-Tom

Removed the power scource then the torx screws around the inside door liner. Then removed the two wires from each of the two switches on the latch assy. Connected the wires to the new latch assembly and put in place. The screws around the inner door lining hold the unit in place. Easy! Easy!