MDB121RFM2 Frigidaire Dishwasher - Instructions

After watching the video the replacement went very easy. The only thing I would suggest is that you replace both springs to equalize the tension.

Spotted the source of the leak at the first heating element under the dishwasher. Removed the brass mounting nut and it was cracked. Replaced with new part from PartSelect.com and the leak was fixed. Apparently the heating element gets so hot it tends to crack the mounting nuts, which results in a leak. Delivery time for part said 3-5 days - mine arrived one day after ordered!

Remove the old part and replaced with new. Done

Just like the instruction video. I pulled the old gaskets out, cleaned the gunk that had accumulated and put the new gaskets in. The tub gasket does not require any cutting or stretching. Just make sure it makes the turn at the bottom of the tub so the door seals properly. The door gasket was very simple to replace.

Replaced arm - SO easy!

When I looked at my prospective home for the first time, the current "month to month" renters made sure to tell me EVERYTHING that was wrong with the place. One of those things was that the dishwasher was broken and beyond repair. Upon moving in, my brother in law asked "Did you try turning it on??" We did, it worked and drained...so why was it "broken?" The lower spray arm kept popping out mid cycle, then would get melted on the heating units at the bottom of the unit during the drying process. I easily found and purchased the part from this site. Once it got here, I literally just had to pop it on, no tools, no mess. Fixed!

Cheked supply water line, water there but not getting into machine.Removed screws that hold machine to counter top, lowered adjustable legs and disconnected water line. I turned off power for safety.Pulled machine out about 8 inches to access water valve from the side. disconnect power supply wires, and water discharge hose, remove two screws on valve bracket. Install new valve and reconnect.

Very simple to repair, cleaned the melted plastic from the heater, received the part within 2 days and pushed the new arm into the 2 bracket clamps and it was done. Since this was an older unit they told me the replaceable part number and the price was very reasonable..less then $30 for the whole job!

Pulled out old gasket and replaced with a new one.New gasket snapped right in place in bottom of door,

Ordered the new roller assembly and in no time the upper rack was back together, up and running. Now to see about replacing the other two rollers and the side rails as they are showing wear and tear.

Thanks for the quick ship.