LEQ9508PW0 Whirlpool Dryer - Instructions

Unplugged the cable and removed the air-vent hose. Removed the rear panel. Marked and removed the wires from both thermostats. Prior to replacing the new parts I used the vacuum and cleaned all of the excess lint and dust from the dryer. I then installed the new thermostat and fuse. Simple..

David

Having read the instructions and watched the tape, I pried out the remaining catch with a flat screwdriver, read about what the color scheme on the parts wasbout and pushed in the correct part. Voila ! Done in probably two minutes.(By an 82 year old woman!)

The dryer belt was delivered promply, afterwards I lifted the top of the dryer and unscrewed the front panel, so it would lower. Then I watch a 5 minute video and it clearly demonstrated how to install the belt. This was my first time, so it took about 30 minutes.

after replacing my heating element, my dryer still wasn't heating. So i replaced the thermal cut-off unit. from ease of finding the part, to ordering and the instructional videos...this was a no-brainer.thanx guys!!

It could not have been easier, thanks to the video displayed when I ordered the part. It was as easy as removing the back of the dryer, taking out the old fuse and putting in a new old. I have NO repair experience, so little I had to borrow the nutdriver from the maintance man at work. I was more then a little leary to try this repair on my own, but decided it was worth all the money I would save not having to call a repair man for my dryer. Sure glad I did I will continue to attempt more repairs on my own.

i replaced the two sensors in the heating element which were very clear in your diagram and it worked perfectly

Checked voltage coming into unit, good. Checked schematic and traced the voltage through the safeties and interlocks. Found the problem at the thermal link. Isolated unit from all voltage sources. Removed part and ohmed the resistance. Found it open. Ordered new link and it arrived before schedule. Replaced and connected wiring, returned power and tested. Worked great! Very easy to find and repair!

PartSelect sent the exact right part, and very quickly! YouTube showed me how to install it. The only hard part was the bulkiness of the drum, which is why I marked "a bit difficult" for the repair.

Got online with parts select, easily found the parts needed and ordered them. They arrived very quickly. The repair itself took all of 5 minutes and now the dryer door stays shut like it is supposed to. Only complaint is shipping was more than the parts but then again, I didn't waste a lot of time running all over town looking for what I needed. So, in the long run I saved money , especially when compared to a calling someone else to fix it.(big bucks for even the most minor service call as you all know).

Did all according to the online demonstration and everything was as easy as 1-2-3. The dryer works like new again.

pop off put in done

Removed power cord. Removed screws in back cover. Checked electrical diagram. Found fuse, checked. New part arrived promptly on time. Was correct part. Tested before instalation. removed one screw that held fuse. unpluged the two wires. Repluged wires, reinstalled screw.on new fuse, replaced back cover and screws. recoupled power, tested. ran perfect.

Slid the new lint filter into slot on top of my 26 year-old Kenmore dryer and it fit perfectly! Ordered part and received it the next day...unbelievable!! Definitely A+ service.

I removed the back of the dryer (after unplugging and shutting off the gas valve) I vacuumed any fuzz and debris. I also removed the dryer vent and cleaned that too. I unscrewed the thermal fuse and replaced it with the new one. I wiped everything down and replaced the back and ran the dryer and it worked! Thanks for your help and for saving me money! My husband was so glad we didn't have to call a service man we celebrated by going out to dinner!

Idler Pulley wheel is broken. it really ez to repair