KUDS25SHWH1 KitchenAid Dishwasher - Instructions

Snapped new pieces on to racks.

I removed the lower and upper basket. Removed lower spray arm unit by removing threaded plug and replaced the wash arm bearing ring. Reinstalled spray arm and plug. Removed Phillips head screw on upper spray arm and replaced wash arm bearing ring and spray arm seal. Reinstalled spray arm and screw. Reinstalled upper and lower baskets. Made test run. Everything smooth and quiet. This is took longer to write than it did to perform the repair. Also made exceptional easy after watching the repair video on partselect.com. Purchase is always easy and delivery was fast. Ordered on Friday and delivered to my door on Saturday.

I used waterproof silicone (Locktite) to adhere the new strip to the door as it would slip off otherwise. I only installed the strip as the included tabs were not necessary.

removed the nut, lifted the washer arm assembly installed new seal in upper and lower ports and screwed nut back in place with new seals. Washer works fine.

Just followed the visual assembly instructions and it was really, really easy. it helped but I also swopped dishwashing brand for cascade complete and that cinched it. saved myself from buying a new dishwasher.

replaced pump outlet top and had to reorder plastic screw before able to fix. relative easy to replace after receiving both parts.

1. Turn off the electrical switch that powers the dishwasher. 2. Open the door of the dishwasher and find the two phillips head screws that secure the top of the dishwasher to the kitchen counter. 3. Remove the screws. 4. Gently move the machine side-by-side a bit while pulling it out onto the kitchen tile (be careful, the water-supply hose, electric cord, and dishwasher drain hose may not be long enough to allow you to pull it out very far - don't break or kink the hoses). 5. Remove (pull off) the black plastic fastener located on the bottom/rear of each side of the dishwasher. 6. Remove the old surround. 7. Lay the new wrap in place and secure with the two plastic fasteners. 8. Push back into place, secure the two screws, check your hoses.

replaced bearing ring & spray arm seal in dishwasher less than 15 mins. Repair was great i could not get parts in my hometown. Found this website you had parts i ordered parts came when you said they would . Great job, i will order again when needed. THANKS

After watching the troubleshooting videos i decided it was the inlet water valve. ordered it and it arrived in two days with regular shipping had some trouble getting the water line loose from the valve as it had been cemented on. i finally over came that by just detaching the four screws that hold the plate to the valve and left the line intact turned it on and checked for leaks it now sounds quite now that its getting enough water and cleans like it did when new saved about 125.00 by doing it my self i might add the screen in the valve was stopped up with mineral build up no wonder it didnt work

Just unbolted the old parts and removed them. Assembled the new pieces, then snapped them into place. All new parts were of a different design, but fit perfectly.

Took old off and put the new on. Careful to be sure the hose end seats against the back port.

The kit came with all necessary parts. The spray arm is now one part with the tube that brings water into unit. There was a video online to show the steps. Not only was this an easy repair but now the dishwasher works like new! I am a very satisfied customer & have shared the experience with several people. The cost was very reasonable. Very satisfied & will use this site again.

The part was correct, it fit and the dishwasher runs fine. All I needed was a phillips head screwdriver to install the upper spray arm.

Removed old mount with screwdriver, clipped on the new mount, screwed on the spray arm. Easiest fix I have ever done! Thanks

ordered this part & it was here in 2 days--very easy to install as it's just one piece now....when it was new, it was a couple of pieces...just screw the new in place...very simple