Models > KSB560MC0 > Instructions

KSB560MC0 KitchenAid Blender - Instructions

All installation instructions for KSB560MC0 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the blender repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the KSB560MC0
1-4 of 4
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

teeth worn out from high speed ice crush

  • Customer: Robert from Lomira WI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 65 of 127 people found this instruction helpful
Put masking tape around the coupling and put the coupling in a vise upside down. took the bottom apart and unscrewed the main shaft screw. ITS LEFT HAND THREAD!!! Screw on new coupling and put the bottom back on.The masking tape is just to protect the finish.

coupling got chewed up

  • Customer: shelley from Homer AK
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
to replace the coupling you take the bottom off the blender and loosen the screws that hold the bracket and fan -then comes the hard part-the shaft screw is bolted through every bit of the guts then into the coupling. It is a lefthand thread. I ended up having to fabricate a piece of metal that slipped into the top of the coupling (in the teeth.) Then I secured the metal piece-it was just a twi inch piece of steel- in the vise, I held the blender and I got a big guy to attack the shaft bolt with a bunch of pressure and a straight screwdriver. It finally popped and I was able to unscrew the old coupling and replace it with the new. Reminds of when guys put on lug nuts and I have to try and get them off. But I saved at least $100.

plugged into transformer at 220 when it was 120

  • Customer: CAT from SEATTLE WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I turned the blender over and pulled off the 4 rubber feet exposing the screws. I then took out the four foot screws. The bottom cover comes off exposing the control panel. I undid the three connections and just pushed (gently) the control panel out--might have to exert a little pressure on the two opposing clips that hold the control panel in. Then I popped the new control panel in and reconnected the three connectors. Put the bottom cover back on and put back the four screws and popped the rubber feet back in. WaLa---it worked!

The rubber blender foot was missing.

  • Customer: Lisa from Lexington KY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Inserted the replacement rubber blender foot in to the socket. Simply pushed it in. Fit snugly. Thanks for being one of the only places you can get a replacement rubber blender foot!
All Instructions for the KSB560MC0
1-4 of 4