Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KSB560MC0

KSB560MC0 KitchenAid Blender - Overview

Get Parts and Repair Help for KSB560MC0

If you know the blender repair part you need, you can browse the list of all parts on the KSB560MC0, or you can search by name or part description. You can also find your part by where it is located on the KSB560MC0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your blender. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the KSB560MC0

[Viewing 2 of 2]

Manuals & Care Guides for KSB560MC0

Click to download
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?


Base and blade are included.



This part sits on top of the motor.



Used on Blenders.


Lid With Cap - Silver




Control Board - Silver


Power Cord - Black


Lid Assembly - Charcoal



Sold individually.



Common Symptoms of the KSB560MC0

[Viewing 1 of 1]
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

teeth worn out from high speed ice crush

  • Customer: Robert from Lomira, WI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 120 of 225 people found this instruction helpful
Put masking tape around the coupling and put the coupling in a vise upside down. took the bottom apart and unscrewed the main shaft screw. ITS LEFT HAND THREAD!!! Screw on new coupling and put the bottom back on.The masking tape is just to protect the finish. read more

coupling got chewed up

  • Customer: shelley from Homer, AK
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
to replace the coupling you take the bottom off the blender and loosen the screws that hold the bracket and fan -then comes the hard part-the shaft screw is bolted through every bit of the guts then into the coupling. It is a lefthand thread. I ended up having to fabricate a piece of metal that slipped into the top of the coupling (in the teeth.) Then I secu... read more

plugged into transformer at 220 when it was 120

  • Customer: CAT from SEATTLE, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I turned the blender over and pulled off the 4 rubber feet exposing the screws. I then took out the four foot screws. The bottom cover comes off exposing the control panel. I undid the three connections and just pushed (gently) the control panel out--might have to exert a little pressure on the two opposing clips that hold the control panel in. Then I poppe... read more