Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KEHS02RMT1 > Parts

KEHS02RMT1 KitchenAid Dryer - Parts

All parts for the KitchenAid Dryer KEHS02RMT1

Below is a list of all parts for the KitchenAid Dryer KEHS02RMT1. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the KEHS02RMT1
29-42 of 178
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$20.98

Stacking Kit

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

$4.79

Washer, Support

This part is located on the drum roller support shaft in your dryer appliance. The exterior of the washer is 1 inch in diameter with a hole in the middle and is made of metal. They are installed alongside the drum support rollers and idler pulleys. If you notice that your dryer is making an unusual sound it could be due to the washer becoming loose on the drum support. They help prevent the rollers and pulleys from bumping up against the brackets they are installed on. If you are replacing the rollers, we suggest you replace the washers at the same time.

$14.88

Terminal Block - Block Only

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

$161.37

Drive Motor with Threaded Shaft - 120V 60Hz

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

$7.11

Blower Housing Seal

This part seals between the blower housing and the blower housing cover.

$19.46

Terminal Block Screw Kit

This kit includes 3 screws and 3 nuts.

$3.02

Screw

This screw is sold individually.

$46.68

Moisture Sensor Wire Harness

$28.05

Door Switch and Actuator Kit

This part recognizes whether the door is open or closed.

$5.36

Seal, Outlet Housing

This lint chute seal, also known as a seal for outlet housing, is used for dryers. This part seals the lint chute to the blower housing in a dryer. It prevents air from leaking around the filter housing. If your seal is broken, damaged, or overused, it can allow lint to bypass the lint filter. In this case, replacing the seal can possibly solve the issues. The tool needed for this repair is a Phillips screwdriver. Refer to the manual provided by the manufacturer for further installation instructions and remember to unplug your dryer from the power source before beginning this repair project.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$11.54

Spray Paint - 12 oz. - White

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a protective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

$45.85

Exhaust Duct Kit

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

$22.59

Lens, Drum Light

This parts covers the bulb inside the drum.

All Parts for the KEHS02RMT1
29-42 of 178