Models > KEHS02RMT1 > Parts

KEHS02RMT1 KitchenAid Dryer - Parts

All parts for the KitchenAid Dryer KEHS02RMT1

Below is a list of all parts for the KitchenAid Dryer KEHS02RMT1. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the KEHS02RMT1
15-28 of 178
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Moisture Sensor


Idler Pulley Bracket with Wheel



This screw is sold individually.



This screw is sold individually.


Cover Screw

Sold individually.


Dryer Drum Seal with Adhesive

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.


Touch-Up Paint - White



Drum Support Roller Shaft - Left Hand Threads

Sold individually.


Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.


Door Catch

This white female door catch is attached to the dryer door.


Outlet Screen Door Grille

Top cover for lint filter.


Blower Wheel

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.


Terminal Block - Block Only

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately


Drive Motor with Threaded Shaft - 120V 60Hz

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

All Parts for the KEHS02RMT1
15-28 of 178