KBFS25EVBL2 KitchenAid Refrigerator - Instructions

A few screws out and in. and the rail just clipped in under the glass

Removed drawers from fridge, removed screws/bolts from end cap, removed end cap with busted hinge pin,installed new end cap with lid , replaced drawers

Move refrigerated and turn off water and unplug elect. Remove ice Ben and guide on right side. Move one screw on the bottom and lousen tow screws on top. Remove ice maker to unhook electrical connection. Transfer parts from old one to the new one . Revise the removal of it and when done .Plug in cord and turn on water. If you have done everything very carefully you will have ice in a few hours.Good luck.

Part arrived quickly from vendor. Slip in hinge attachment on both sides were pushed in for removal and new lid installed in 5 minutes.

removed drawers and glass; removed screws from end cap. removed screws from metal drawer runner. popped end cap off. reinstalled new end cap; attached metal drawer runner; cleaned everything and put glass back in as well as drawers. sweet

Thought I needed a new filter. Did not solve the problem. I returned the filter to partselect as per instructions. Will order from partselect when I need parts.

Lift drawer off sliders. Remove two screws holding drawer slider. Remove two screws holding left side pantry end cap. Screw new end cap into place. Screw draw slide into place. Replace drawer. It was a quick repair and finding the replacement part was real easy since the right side end cap needed replacing last year for the same problem. Weak design, but that's another story.

I lost the instructions so took one piece at a time off and put it on the new part. Then mounted it in the refrigrator. Works better than when it was new. Thanks for very quick shipping.

Very easy as described by everyone else here. One tricky part slowed me down a bit. When you try to remove the End Cap after removing the screws you find that it is connected to the climate control bar on the rear part of the fridge cabinet. There is no screw connection, just a tab on the end of the piece, near the center of the cabinet. Just pull the End Cap away from the side, pivoting the entire unit toward the center of the fridge. This will allow the tab to slide out of the opening in the back.

Easy...

Remove two hanging drawers (fruit and vegetable). Remove top glass and two supports for the chef's pantry. Removed chef's pantry. Remove three large screws from the pantry end cap (front, middle and rear). The end cap can now be removed. NOTE: The pantry drawer slide will still be attached to the end cap. Once the end cap is removed detach the rail by removing two smaller screws. TIP: Use either a nut driver or socket verses a screw driver it works out better. At this point replace the end cap and install in reverse of removal.

The vertical mullion rail had detached from the plastic panel which was secured to the door of the refrigerator. Three wires were exposed. Plastic panel removed (with the exposed wires), new panel (already attached to the new mullion rail) had wires enclosed in plastic, which were then plugged into a corresponding plug on the refrigerator door. Slide the mullion rail on the plastic hinges (one on top and one on bottom). Tighten the bolt on the plastic panel, and voila! A 5 minute job for this 60 year old female.