KBFA20ERBL00 KitchenAid Refrigerator - Instructions

Took the old crisper apart and removed its solid part from the plastic that was broken. Put this solid part over the new crisper and all clicked together.

I had ordered some other parts for something entirely different off your website and service was great. So after almost ten years of a dark refrigerator, because of a defective switch, I decided to see if you had the part to fix it... You did and the part got here in 3 days. I had a working light switch and all the light in the world where my husband needed it most (in the fridge). It took me at the most ten minutes to replace the part. All is well now and I have a happy husband who can find the leftovers just fine. Thanks for your great service!

I was impressed at how fast the delivery came. Move refrigerator,cut off water & power, detach &* reattach part and test.

I followed the instructions from your video. I did this replacement all by myself. I am a 64 year old woman and have never done anything like this before. It could not have been any easier.

Thanks to a very patient husband. He looked at the situation and methodically took the freezer drawer apart by trial and error and was able to replace the old shaft with the one we had ordered. We do not understand why this basic information is not in the manual or on the internet. It was relatively easy once we knew in what order to take the drawer apart.

Replaced icemaker and used wire harnnes and plastic cover off old one. Real easy!!

The ice maker change out was easy. The problem was the part came with a different filler cup but the one needed was supplied. Changing to the other cup required taking the ice maker apart and installing the other filler cup. Go to the parts list and find the filler cup. Use instructions found there to change to other cup and then install your ice maker.

Drawer guides on the bottom of the crisper frame could not be glued back into place. The replacement frame arrived in 1 day. Be gentle removing crisper vent shutters, trim, and the metal reinforcement channel from the old frame! Re-install them on the new frame then hang the assembly in the fridge. Slide the drawers and glass back into place. I added a dab of clear silicone grease (bulb and socket lube)on each drawer slide.

removed bins and meat/cheese cover. Removed slider with two screws. Removed broken end cap with two screws. There is a plastic linkage to a vent in the rear. Removed three pieces from inside the end cap. These are are all snap-in parts, but require manipulation. Took some time to figure out. Same on reinstall. Cleaned up drawers and cover. Easy!

I found the video and write up’s very useful for repairing a newer refrigerator that just ran out of warranty.

We tried repairing with a new switch which was very easy to install but it didn't fix the problem.

My Maytag side by side had stopped making ice suddenly. My wife loves her ice. We were at a loss until we found the Parts Select website. I ordered the new icemaker and the dual water valve. After watching the short installation videos I changed the parts on my refrigerator and in about 45 minutes I heard the sound of ice dropping into the bucket. With the wide selection of part and easy to understand videos we had Ice and my wife was happy. I recommend this site to anyone that wants to repair a malfunctioning appliance

Piece of cake. Took out old filer and put in new one!

First off I had no idea how a fridge worked or where to begin and the troubleshooting section of the manual was a joke. So I took the back panel off made sure the coils underneath were clean. Took out the back panel of the freezer and made sure that nothing was frozen over and I hadn't seen excess water on the floor so ruled that out. I knew the condenser was still running so I took a shot in the dark. Ordered the part and waited for it to arrive. It took me 3 minutes to open the box and install it. Immediately knew it was working replaced the back panel and moved the fridge back.

Removed plate from back of fridge,removed water lines, removed valve from plate, put new valve on, reconnect hoses, reinstall plate.