JW2000W Jenn-Air Washer - Instructions

I turned washer over, took off old shredded belt. One of the pulleys is spring loaded so I just held it in as i looped the new belt on. Easiest repair I have made on a washer!

We're not repair people. So when calling around for the replacement belt no one had it. Everyone said that the belt went to a dryer. We simply inspected the machine. Located the worn belt which was on the bottom of the washer machine went online and ordered the belt. Thank you so much you guys really saved me. I will always recommend you all to everyone that I know. Your system works Great! Thanks Part Select!

I got the part the very next day, very easy to replace. Replaced the belt as well. Parts Select is the best. Vert straight forward repair.

found your web site and the helpful hints Thank you it works wonderful even washing heavy loads

looked at the digram on partselect and did the repair

I watch the video on part select, order the pump and belt fix it 25 min. very easy cost of parts $96.00 estimate to come to the house $70.00 plus parts.

I am a single women and was very proud of this accomplishment:My washer began making horrible noise when agitating (only), I did some research (on this site) on what the problem could be. I decided to replace the drain pump and belt. It was so much easier than I expected and now, it works with no bad sounds. I have a very simple model, nothing fancy and I hope that is why it was so easy.. not much going on. I am proud of myself since I did all this on my own.. no man helped! :)

just a matter of 1 screw to remove and replace part ordered part 1 day and came in next day with regular mail. was a surprise for my daughter, she went on vacation and i fixed while she was gone. she was using different items to place in slot to engage each cycle.

I lifted the washer and supported it in the front, then slipped the drive belt off the large agitator pulley. I then tried to turn each of the 3 pulleys under the machine. The Drain Pump was definitely seized. I removed the small access panel in the rear of the machine, removed the 2 drain hoses by releasing the clamps with pliers. Removed the 3 screws with a socket wrench and removed the pump. The new pump was a perfect fit, and we are back up and running. Thank You.

Followed existing instruction to get tub and transmission out of the machine but we couldn't get the transmission free. Wound up taking the tub with the transmission attached to an appliance dealter who said we needed to remove the retaining clip on the bearing at the top of the transmission (inside the tub). We didn't have the tool to do that so we left it at the service center (60 miles from our location) and paid $291 for the repair then had to reassemble the unit when we got it home.

I watched the video. Not as easy to hand start the screws ,as shown, in the new hinges (I replaced both) I used a drill with a phillips bit to pre start the screws with the hinge in a vise. It then had threads cut, which made it possible to hand start, and I finished with the drill/bit to tighten up.

The old worn belt came off with little difficulty, using the screw driver to coax it over the wheel. And the new one went on just as easy.

Replaced pump and installed new belt and machine is good as new.

Unscrewed one screw and replaced with new part.

I watched the video you sent with my order conformation and it was very helpful and accurate. I will order from you again. Cecelia