HDA3740G02SA Hotpoint Dishwasher - Instructions

whole assembly screws out, replacement was a breeze. I love this site. Parts came quick

Put rack in place and snapped new one in.

Quick and easy...a 7 yr old could have done it.

We removed old gasket, cleaned surfaces and installed new gasket.

I removed the plastic inner door liner, removed the timer assembly. Replaced both plastic parts, Detergent cup release arm and dispenser release timer lever. The most difficult part was reassembling the timer lever spring. Long nose pliers made it simple. Works like new.

Turn off the power at the breaker panel. Turn off the water supply that goes to the dishwasher. Remove the front lower panel to gain access to disconnect the water line and electric. Now remove the two screws that connect the dishwasher to the countertop. You should be free to slide the dishwasher from under the countertop far enough to remove the drain hose. Slide the dishwasher out all the way and lay on the floor door down. Loosen the two clamps that hold the motor up. Remove the motor bracket, (should only be one screw. Disconnect the wires from the motor. Now just pull the motor down and out. Repeat the process to install the new motor. I took several pictures before I started removing anything. The instruction that comes with the kit is very good. Their will be parts in the kit that will not be used. Not to worry!

I popped out the stoppers at the end of the gliders. removed broken rollers and slid on new rollers.re-installed stoppers, tested all functions. tested good

Pop out the old baffles with the help of a screwdriver, push in the new parts in their places and done.

We watched the video describing the replacement process, cleaned the groove after removing the old gaskets, and installed the new gaskets as sown in the video. The installation passed the test washing a full load after the job.