Models > HDA2000F00AD

HDA2000F00AD Hotpoint Dishwasher - Overview

Get Parts and Repair Help for HDA2000F00AD

If you know the dishwasher repair part you need, you can browse the list of all parts on the HDA2000F00AD, or you can search by name or part description. You can also find your part by where it is located on the HDA2000F00AD by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for HDA2000F00AD parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the HDA2000F00AD [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$0.64

RACK SLIDE END CAP

This part attaches to the rails, for the upper rack, to prevent the dishrack from sliding all the way out.

$10.51

Upper Roller and Axle - Kit of 4

This is a package of 4.

$8.77

Lower Front Dishrack Wheel

This wheel is located on the front lower rack. It is sold individually and comes with the attaching axle.

$9.93

Lower Rear Rack Wheel and Axle Kit

This kit contains one wheel and one axle. It is designed for the rear lower dishrack. Sold individually. Order quantity needed.

$8.27

Corner Tub Baffle - Lower Left

The left and right side baffles should be installed/replaced at the same time. Right side baffle is sold separately.

$7.04

Corner Tub Baffle - Lower Right

This baffle fits the lower right hand corner of some dishwashers. It is black and has a matching left hand lower corner baffle. It is recommended that you replace and install both left and right at the same time.

$103.09

Lower Dishrack with Wheels

$13.02

Silverware Basket

This silverware basket is gray.

$46.61

Water Inlet Valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the d...

$69.16

Upper Dishrack with Wheels

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broken upper rack roller, rack kept falling off the track

  • Customer: Doug from Columbus OH
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 367 of 370 people found this instruction helpful
Used the pliers to remove the broken roller. It came off in pieces. Slid new one on.

Cap on end of roller track was a bit of a challenge. It sort of twists & pulls off. read more

Rollers fell off lower rack of dishwasher.

  • Customer: Lloyd from The Villages FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 362 of 363 people found this instruction helpful
First removed four old wheels. then attached four new wheels to lower rack by pressing into slots. read more

The stud assembly in the middle of each wheel no longer stayed inside the wheel.

  • Customer: Wendy Baldwin from Stowe PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 361 of 365 people found this instruction helpful
Just pulled off the old wheel. I just had to push in the stud to the wheel and pushed it on to the rack of the dishwasher. Very easy repair! Only disappointing part was that it bothered me to have to purchase the stud with the wheel. I was told they only came as the set. I only needed to purchase that inside stud. My wheels were fine. read more