GT1928PAHW Maytag Refrigerator - Instructions

Reversed removal steps to assemble the new rail.

The repair was really easy - once I figured out how to take the broken drawer glide off the drawer. I had to use a hammer to "push" the old glide back. Then it popped out and the new one slipped in in two seconds. I was shocked that the new glide rail came within 24 hours of ordering it. It took me more than 24 hours to find the time to take all the stuff off the shelf so I could take out the drawer and make the repair. Thank you!

Sorry for delay in writing. Part I ordered arrived two days ago and it was exactly what I needed. Knowing that there will be problems even with the smallest job I procrastinated starting. When I did start this morning I foud I had to completely remove the ice maker and disassemble it in order to install the water fill cup bracket. The challenge was reassembling the unit. Not hard for an experienced repairman but a challenge for layman. Everything is thing is back to gether now and power on cooling down the refrigerator. Won't know how successful it was until turn on water and ice is formed. If it works this saved $75 just to get a Sears repairman to come out and tell me what would be needed to fix the refrigerator and $1,000 if I had to buy a new refrigerator. Extremely satisfied with service I received. Thank you.

Removed the freezer door and replaced with the new hinge.

Took ice maker out all together we removed 4 to 5 screws had to remove axel to get the broken piece out and new one in my husband said it was easy in and out in about 15 minutes saved about 150. 00 Thanks partslect

Repair was very easy. Removed old cover (6 screws) . Placed old cover on new cover and counter sank screw holes to new cover. Installed new cover. Less then 15 min.

unplug refrigerator, take backing off with nut driver. Pull old blade off and put new blade on. Put backing back on and plug in.

The shelf did not fit exactly into the bottom slot but forcing it a tiny little bit did the trick.

The main issue is that my supports are NOT held on by screws -- they are behind the fridge wall and can not be removed. So this is my solution (ignore the 'fix kit' -- it is useless and is just this part plus a metal screw. It cost me $20 to find this out). Here is what I did: 1) Cut off the old support with a knife. 2) Get a small toggle bolt (I used 1/8" x 2", < $2 from Home Depot) and thread into new support. 3) Dig around in insulation to make sure there is space for toggle to flip open. 4) Install!!!! Wish I'd thought of this before :-)

empty frezzer take door off unplug wires going to ice maker unscrew/bolt icemaker replace door take motor cover off ice maker remove screws on motor replace ice cup and put every thing back together

Got the part in 3 days popped it on fit perfectly and problem solved

removed the back cover unplugged the unit removed the old fan blades installed the new easy to pull off and easy to install

removed old mount with allen wrench replaced with new mount