Really easy to attach new grill at the bottom first (saw that on another persons installation instructions) then used a Philips screwdriver to attach top of grille in the two places one at each end., not a problem 75 year old gal, If I can do it you can do it...
vent plastic broken kept vent falling down on stove
remove old vent that was held in place by clips and two screws re-installed. Only problem is that should have ordered new clips was not aware that they did not come with the new vent
removed perimeter screws from the bottom side and the lower cover is hinged at the wall side. Motor is visible and easily removed with two screws. Take of the old one, install the new one, and reverse the procedure to put the bottom cover back in place. Will nee helper to hold one side of the bottom until couple of screws can be put in on the other side.
Not so sure this would qualify as "instructions", but I only needed a screwdriver because the "D" rings of the old vent filters broke off and I had to pry to old ones out. Keep in mind, I am mechanically disadvantaged and can barely change an A/C filter ... that being said, all I did for this order was input my Model number and PartSelect found the correct replacement part. I receive the parts super quick (faster than the other 2 purchases I did that day). The only bummer was the packaging ... super huge box for small tiny parts. Otherwise, I now know where to go for replacement parts. This project should be a "no-brainer" for most DYI's, so getting the right parts with just a model number was lifesaving for me :0)
Replace charcoal filters in microwave - vents inside.
Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.
Microwave made a heavy buzzing sound and then stopped heating
Removed cover (lots of screws), Removed base, Removed inside covers to epose transformer, HV diode, capacitor and Magnetron. Removed HV transformer and labeled wires. Removed door switch. Removed Magnetron and replaced. Re-installed door switch and HV transformer. Connected wires and re-installed internal covers. Installed base and tested unit. Installed cover and re-installed Microwave. Has been running a week just fine. Take a lot of pictures with your phone during the whole process. This will help with getting things back exactly as factory.
Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
Was this instruction helpful to you?
Thank you for voting!
A glass fell out of pantry onto glass tray and broke it.
I called the repair/parts number to make sure I had correct parts and the young lady instructed me as to the size of the serving tray; within 48 hours we had the VERY carefully wrapped carton opened and back in the microwave, working perfectly. Thank you. We'll recommend you to our friends!
Slid them out and slid them in. Best part - ordered them at Noon on the Friday after the 4th of July and they arrived at 12:10 the next day - standard shipping.