GCG1700L0II General Electric Trash Compactor - Instructions

Like others said, I think the old motor itself was good but I will never know. I could get it to work by working the chain to move the gear. The good news is the new motor made everything work. It is a little quieter. I kept the old gear instead of using the replacement that came with it. Two nuts are hard to get to because the gear and chain is in the way. I had to pull on the gear away from the motor to gain access. I expected my 3 year old GE compactor to last longer than it did. I don't recommend buying another one. The new motor has been working good for 1 week now. I can't believe how fast the delivery was. Only 2 days. 237 dollars.

i cut the yellow and blue wire in the middle and crossed them and spliced them back togetor.

Unplugged unit. Took basket out, slide unit out, remove top and front panel. Remove power switch to get to the two directional switches. Disconnected the one on right be cause the arm was loose and not operating. Removed it and replaced it with new switch. Part #WC21X10004. Put it all back together and it works right.

After removing the trash bin assembly, I removed the two screws securing the main compactor body to the cabinet, and then rolled it out and disconnected the power cord. I laid it on the floor on it's face on a piece of carpet so as not to damage the flooring. I removed the three screws that secure the motor axcess cover, and then the screws on each side of the motor box to remove it. I next removed the screws securing the chain drive cover on the bottom and removed it. I unplugged the two electrical connectors for the motor, and then removed the "C" clip that secures the drive gear on to the motor, then slid the gear off the shaft. After removing the four nuts securing the motor to the base plate, I removed the old motor and installed the new one, leaving the nuts loose. The instructions tell you to be sure to use the new gear that came with the replacement motor as the new motor has more torque. I slid the new gear onto the motor shaft and re installed the clip. I used a piece of paper between the gears to set the proper spacing as per the instructions, and then tightened the mounting nuts. The old motor has one three connector plug and a single black wire that connects directly to the centrifugal switch with a female spade connector, while the new motor has two plugs, one for the three wire connector and one for the black wire. The male spade on the new plug was bigger then the one that I removed the black wire from on the old switch connection, so I had to remove the female connector and replace it with one that would fit. After re installing the chain cover and motor box, I stood the compactor back up, put the trash bin back in and cycled it one time to make sure it was working properly, then put the motor cover back on and re installed it back in the cabinet. As several other posters noted, the problem was the centrifugal switch, not the motor. The new motor is not only more powerful but also has a re designed switch that looks more robust and should last a lot longer.