Models > FMV156DCA > Instructions

FMV156DCA Frigidaire Microwave - Instructions

All installation instructions for FMV156DCA parts

These instructions have been submitted by other PartSelect customers and can help guide you through the microwave repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the FMV156DCA
31-33 of 33
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

microwave was sparking

  • Customer: Chad E from Newmarket VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Easy fix for my microwave. The cover just slips out, no tools needed.The best part about this fix was dealing with PartSelect. I recieved my part in less than 3 days but it was damaged. PartSelect overnighted a repacement and I am back in business.

Everthing works except heating.

  • Customer: Michael from Waynesboro PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
This is an OTR microwave oven, needs to be removed to diagnose problem. I did not diagnose problem properly, I searched online for possible causes, read that (99%)percent of the time the interlock switch was bad and replacement should solve my problem. It was also stated to be an easy fix,15- 45 minutes depending on ability. I ordered the relay switch. Took the oven down then removed outer shell. With my multimeter I began to test, fuses(2), interlock switches(3)and transformer. 3 interlock switches were ok, fuses were fine, and had power to the transformer, meter could not read output of transformer because of high voltage, (2300v). I'm down to magnetron (about a hundred bucks) or the touch pad/ circuit board. I have a countertop micro that I'm putting in place of the OTR. As far as Partselect, my item was shipped and delivered on time, instructions for changing that part was quite accurate. Would order from here again, just do my homework first.

MICROWAVE WOULD RUN AND COUNT DOWN BUT NOT HEAT

  • Customer: John from Selma CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers, Wrench set
  • 0 of 0 people found this instruction helpful
REMOVED UNIT FROM ABOVE STOVE REMOVED OUTER HOUSING, INTERIOR SHIELD AND TESTED THE 4 DOOR RELAYS. ONE WAS NOT WORKING. REPLACED PARTS AND RE INSTALLED UNIT OVER STOVE.
All Instructions for the FMV156DCA
31-33 of 33