FDB1502RGB4 Frigidaire Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water leaking from around the door bottom
Removed old gaskets, cleaned area with rubbing alcohol and installed new gaskets. I let it sit for an hour and ran a load of dishes. No leaks, very easy fix.
Parts Used:
-
Brian from Shenandoah, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water leading from bottom of door
Just like the instruction video. I pulled the old gaskets out, cleaned the gunk that had accumulated and put the new gaskets in. The tub gasket does not require any cutting or stretching. Just make sure it makes the turn at the bottom of the tub so the door seals properly. The door gasket was very simple to replace.
Parts Used:
-
Henry from S Burlington, VT
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
Spray arm was melted on end from heating element in bottom of unit. Dishes were not being cleaned well.
-
Sandra from Wilton, NH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
upper spray arm falls 0ff
the part was shipped really fast and was a perfect match for the old part. super happy with the results. thank you partselect
Parts Used:
-
randell from manchester, TN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Renter broke latch
removed screws for control panel .Screws are a tork type so you need that type of driver to remove them . simple 2 screws to remove latch . Disconnect the two electrical connections reinstall new latch in the reverse order .Put control panel back on don't over tighten screws .
Parts Used:
-
Gary from Jefferson, OR
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The dishwasher was "broken" and it needed to be replaced...
When I looked at my prospective home for the first time, the current "month to month" renters made sure to tell me EVERYTHING that was wrong with the place. One of those things was that the dishwasher was broken and beyond repair. Upon moving in, my brother in law asked "Did you try turning it on??" We did, it worked and drained...so why was it "broken?" The lower spray arm kept popping out mid cycle, then would get melted on the heating units at the bottom of the unit during the drying process. I easily found and purchased the part from this site. Once it got here, I literally just had to pop it on, no tools, no mess. Fixed!
Parts Used:
-
Brandie from Summerville, SC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
No water comming into dishwasher.
Cheked supply water line, water there but not getting into machine.Removed screws that hold machine to counter top, lowered adjustable legs and disconnected water line. I turned off power for safety.Pulled machine out about 8 inches to access water valve from the side. disconnect power supply wires, and water discharge hose, remove two screws on valve bracket. Install new valve and reconnect.
Parts Used:
-
thomas from Neptune, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
The lower spray arm became loose and melted on the heater.
Very simple to repair, cleaned the melted plastic from the heater, received the part within 2 days and pushed the new arm into the 2 bracket clamps and it was done. Since this was an older unit they told me the replaceable part number and the price was very reasonable..less then $30 for the whole job!
Parts Used:
-
Brian from Weaverville, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
door leak
Pulled out old gasket and replaced with a new one.New gasket snapped right in place in bottom of door,
Parts Used:
-
Andrew from Republic, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:More than 2 hours
Was this instruction helpful to you?
Thank you for voting!