frezzer iceing over and not cooling the refrigerator
Just removed the two screws and unpluged it. Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator. Thanks for the fast delevery. Will do busness with you in the future.
The drawer had been damaged probably from not closing the drawer and refrigerator door was shut.
We removed the front of the drawer from the old drawer and reinstalled on replacement drawer. It only took about 5 min. to complete. Shipping was Prompt. The person that helped to establish the Part no. was very helpful.
Got the new one and took the face plate off the old and sliped it right on to the new one. I noticed that the guide edges on the new Drawer are made better. That is added bennie.
The upper vegtable drawer had broken on both sides.
First we took the the old drawer out and pride off the front clear covering on both sides. Then we placed the front covering on the new drawer and fit it in place. This had to be done twice since it did not take the first time. It had come loose after a couple of days and we snaped it back into place. It has done fine since.
I received the drawer within 2 days of ordering it online, which was extraordinary. I removed the front of the old drawer, as instructed and placed it on the new drawer. I then replaced the drawer in the refrigerator and the job was complete. The entire experience from beginning to end was simple and completed in very little time. Had I known it would be this easy, I would have ordered the drawer sooner.
I removed old drawer. Then I removed the front face panel. I had to wedge the knife in the front bottom so I could remove the face. Installed face on new drawer. Inserted new drawer in fridge. Voila ! Works great.
took door off. sanded rusting hinge and greased. installed door hinge washer. I had to install a larger washer over hinge bearing to help support the door where it was rusting. no sweat. works like its new. thanks to you guys for having the parts.
I didn't know the front of the drawer could come off so it was pretty gunked up with dried meat juices that had leaked. The fit was very tight. I had to really work the putty knife to get it between the front and the drawer at the bottom where the catch is. I was afraid I would break or chip the front before I got it off but it handled the pressure pretty well. Had to use some force though. Once I cleaned the front it slid right down and snapped into place.