Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ESL22XGRBBS

ESL22XGRBBS General Electric Refrigerator - Overview

Get Parts and Repair Help for ESL22XGRBBS

If you know the refrigerator repair part you need, you can browse the list of all parts on the ESL22XGRBBS, or you can search by name or part description. You can also find your part by where it is located on the ESL22XGRBBS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ESL22XGRBBS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.07

Temperature Sensor

Also known as Thermistor. This part is used to sense the temperature in the cabinet.

$34.13

Ice Bucket Auger

When activated, the auger rotates and pushes ice out of the bin through the chute to the user.

$12.71

Defrost Thermostat

This part acts as a safety device against over heating in case of mechanical failure.

$53.09

Dual Inlet Water Valve

This double outlet water valve has quick connections. This valve has 1/4 and 5/16 John Guest fittings for the outlet lines and a 1/4 compression fitting for the inlet line.

$20.34

Drawer Slide Rail - Right Side

$61.59

Ice and Water Filter

NOTE: As per the manufacture this is an updated water filter. If you have never installed the updated filter or your old filter was made by Culligan, you may need the adapter to install the filter. See Related Parts. Sold individually.

$153.95

Ice Maker

Replacement icemaker kit - electronic. This kit includes a 4 pin round plug-in connector, 6 post plug-in connector, tube and fill cup.

$18.63

Drawer Slide Rail - Left Side

When looking inside the fridge, this white drawer slide rail is located on the left side of the refrigerator. Rail ONLY.

$9.78

Dispenser Door Assembly or Flapper

This part mounts in the ice dispenser. **** The crank no longer comes with this part. You can use original crank. The crank is sold separately depending on model number of appli...

$39.18

Defrost Heater Harness Kit

This dual heater kit replaces the single heater. It's redesigned to use two heating elements for a better defrost cycle.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Refrigertor water dispenser not working BUT ice machine is working

  • Customer: ralph from bristow, VA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 868 of 947 people found this instruction helpful
The very first symptom here is important! The door water dispenser is not working but the ice macine is working. You may only have a frozen water tube in the door so do the following before diagnosing that your solenoid valve is bad: 1) the tube usually runs under the front of the refrigerator and usually has a quick disconnect. Undo the connection and pr... read more

Plastic Auger blades broke in ice tray

  • Customer: Tim from Newport News, VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 490 of 516 people found this instruction helpful
I used a digital camera and photographed the assembled unit and the metal blades before I started the repair. Then, I removed the top screw on the clear shield. Flip over ice tray and removed two Phillips screws on bottom. Exterior plastic white cover comes off next. The cover sides have hard push-in white plastic tabs. Push them in; pry up top cover with sm... read more

Ice box and freezer would not get cold,the back wall of the freezer was covered with ice

  • Customer: Greg from Aledo, TX
  • Difficulty: Really Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 486 of 525 people found this instruction helpful
1. I had to defrost the ice off of the back wall of the freezer with a blowdryer.
2. Removed the four 1/4'' screws and removed the back panel.
3. Defrosted all of the ice off the coils and heater.
4. I replaced the defrost thermostat and heater by following the directions that came with them. The directions are very clear and easy to follow. I... read more