EMO4000JSS04 General Electric Microwave - Instructions

I followed the directions posted by others - they were perfect. This was a very easy process. The screws on the motor were hard to take off because they were put on at the factory with equipment is my guess. But the process was very easy. The turn table is working. I still have the noise but now realize that is from the magntron fan, which I am not going to replace given the age of the microwave. At least my food is heated evenly with the table turning and I can live with the noise until I see the price I want to pay for a replacement microwave. Thanks all!!!

very simple as you stated - unscrewed 5 screws on bottom of microwave - attached drive motor and coupler - replaced screws - it was done - Hope to get some extra monies so I can repair other appliances in our home - You were very reasonable and shipped in 3 days - this was during the holidays - I was impressed and delighted! Thank you partselect - I will tell all my friends about you!!!!!

Found blowup drawings inside unit, which helped identify what I had to remove. Had neighbor assist in lifting unit from wall mount, unit slides easily from rails once top bolts are removed. Pay attention to where all the screws go as you remove them, some inside assemblies will have to be removed or loosened. A good guideline to go by is all black screws hold internal assemblies, the bronze screws go in the back side and the chrome screws go on top, sides, and front of the unit. I was able to lift unit back on rails without any assistance.

Removed microwave bottom cover ....removed motor....replaced...parts fit perfectly...your-company is the best...service, price & support!

removed access panal, found soft switch as discribed on your web site. removed and replaced.

opened door, removed and replaced bulb

Removed the bottom plate screws from the microwave. Disconnect the wire harness. Replacement of the light sockets is easy. The female terminal connectors that connected to the bulb sockets were corroded, so I had to go to the hardware store and get replacements for those also. Replacement of those was unexpected but straightforward.

1) I unplugged the microwave. 2)I removed 5 screws which allowed the bottom of the microwave to open. 3)I unplugged the drive motor. 4) I removed 2 screws holding the bad motor and removed the motor. 5) I installed the new motor with the same 2 screws and completed the replacement by doing steps 3,2,1. I reset the clock after testing. Easy-Peasy. My mother was thrilled. She was using it that way for about a year because she thought a repair person would charge too much.

Opened the bottom panel of the microwave, removed one screw from the motor, rotated motor aprox 1/8th turn and pulled it down, Pulled off wires and then reversed the operation. Was easy and works great. I was really surprised how fast the new part was sent.

It was great...Thank you for having the part available...

unplug microvave,remove 5 screws from bottom of microvave. Motor is in the center. unplug remover remove last screw. replace motor plug motor back in and reverse steps. so easy!

PartSelect had helpful repair instructions on-line which made the repair easier and faster. Unfortunately, there were other problems with the oven that immediately blew the new fuse I had just installed. It was then determined that additional repair would most likely cost almost as much as a new microwave.

I'm in the 1% it wasn't the motor. There's a small amount of voltage going to the motor

My daughter hand installed bulbs without a problem, took a minute and used a phillips to reinstall the cover. I shopped on-line because I wasted two hours between Lowe's and Home Depot trying to get the right bulb. I did think your postage was crazy high, otherwise glad to get the right bulbs to solve the problem.

Remove light cover. Replace bulbs Note. Light bulbs are 40W,Too much heat for bulbs & sockets