EF36IWFSS Refrigerator - Instructions

unscrewed the old one! installed the new one! That simple. And I'm female, how easy was that!

Loosen to screws under ice mold and unplug power cord from icemaker.Lift out complete unit. Remove cover on ice maker,then 3 screws on end plate and remove end plate. Remove 2 screws that hold ice mold to frame. Make sure that the thermostat is moved to new mold. Reverse order to install new mold.

My ice maker would not produce ice. I removed motor module which involved removing ice maker from freezer, removing motor module cover and 3 screws. I found short (burnt place) in copper of existing module. Ordered new motor module, replaced, and all is fine. Great service, quick delivery and correct part.

Dropped down the housing for the water filter, twisted, removed item and slotted in the new filter. Easy as pie.

Used screw driver to pop out old switch. Used pliers to hold wire connection from fall back into slot on fridge. Inserted new swith into plug and pressed new switch back in place.

took out the old cover. then put in the new one! Easy as that. Thank you.

took old one out installed new turn left out turn right in

Required removal of the entire endcap piece. A total of 5 screws. Hardest part was realizing i didn't have the right size socket wrench to start. Got that and replaced all 5 screws in under 5 minutes. $18 for part, $10 for tool.

Used the instructions on your site.

Had to remove the ice-maker (also easier than trying to work inside the freezer letting all the cold air out). A few mounting screws and an electrical connection in the back. After it was out you will need to remove the cover (not the superficial cover that just pries off) where the gear is behind it, just far enough so you can get the mounting tabs on the ice-stripper in. In order to to move this cover out, after removing the screws (the obvious), you'll need needle nose pliers to ever so slightly squeeze the plastic clips together that hold the plastic movable bracket and the metal ice level arm/switch, so it will pop out. Once you have room to put the ice stripper in, it should just all snap back together, then proceed in reverse to put it all back together.

I had several times tried to get the old switch out but with no success. Ordered the "repair kit" and followed directions for removing old switch (there is a plastic spring clip on one side). Easy to unplug the old switch, plug the leads into the new one, snap the new one into place. Took about 5 minutes total--piece of cake. I wish I'd thought to try this years ago when the old switch began to fail.

removed the old filter. unwrapped the new one. peeled off the protective foil. inserted new filter as directed. placed old filter in sink to drain. ran "water" from dispenser to purge air from line. Shazam!

20 seconds. Easy Easy.

I'm uoset that I sat and looked at the broken piece for a month wondering"what the heck is this going to cost me" The more you spend on the appliance the more they break. The repair was too easy. Remove the 2 drawers, remove the bottom draw and there are 3 nuts you need to back off. The whole piece comes off really easy. I left the drawer glide on and took it off after the whole piece was out. Attach the glide to new piece put it in place and screw it back together. Now gow wash the drawers and glass that you have been putting off and reinstall them. Start to finish 10 minutes,.

I did remove the run capacitor of the starthing kit of compressor and another one new. It work fine.