EER3000K02BB General Electric Range - Instructions

The part arrived the very next afternoon. My husband was at work, so I decided to give it a try. After reading other repair stories, I began by shutting off the breaker to the oven. Next, removed the racks. I then used a socket to remove the two screws on back plate. I then VERY CAREFULLY and slowly pulled out the element a short distance, just to see the connections. I used a magnetic refrigerator clip to hold onto the clip so it wouldn't go back into the insulation in the oven:(someone else suggested this---good suggestion) I slid off the connectors and slid them back onto the new element. Pushed it back in and put screws back on.

Our son came to visit! The element was replaced in no time!

I did not separate out the wires that went to the left and the wires that went to the right when I removed the element. When I finished the repair the two days later after getting the proper bottom element ( the folks on the phone are great, much better than just figuring it our o form plan view in pictures), I blew out the oven control chip, it was spectacular!. Subsequently I disposed of this newly made oven sized paperweight and replaced it with a new oven, which upon reflection of my arts and crafts abilities, I should have done in the first place..

Installed new guides with a nut driver without any problems.

Dear PARTSELECT

My experience with you was spectacular!!!!

The oven broiler burner went out on a Sunday afternoon while my wife was using it to cook for our family dinner. We ordered it that day and it was received, installed, and working on Tuesday afternoon...



How could it be any better?



Thanks



George Crady

Removed 2 screws that held the element to the back of the oven, took off the wire connections and did the same in reverse. . . . .

Removed 2 screws, raised and propped up stove top, removed 6 screws, unplugged eelctric connection to old asembyly, removed old hadle, reversed process to install new handle.

Went to the rear of stove took off bolts attach, slipped the old element out and inserted the new one then re-attached the bolts.

Repair was easy. 1. Turn off the electric to range. 2. very carefully remove the door(makes it real easy to access inside the oven.) 3. remove the 2 screws but be careful. 4. remove the two push on teminals. 5. The wires are very very short so they snapped back into the back of unit. 6. pulled out range and took off the 5 screws holding the small metal piece protecting all electrical wires...7. found the two terminal wires and push them on new terminal leads. 8. screwed the elements two screws back in, 9. replaced the small back with the 5 screws. 10. cleaned the floor behind the range and pushed it back in place.... DONE.... element works fine...tested it. however not cooking with oven today with temps outside at 104-105 ...will wait till it gets a little cooler... but all in all it was a piece of cake.....

Very easy to fix with two people and works great

Took out the old control module and removed the sticker and reattached sticker to new part and installed the plugs, put the screws back in and it started working, thankyou so much.

The only tool needed was a nutdriver to remove the lamp socket. I needed my head mounted light to see what I was doing, and everything went smoothly from there. Simple job.

remove rear panel cover, removered four screws that held control panel, disconnected colored wires, removed circuit control board, reinstall new board and connected color coded wire to the correct spot on the board, plugged in 220 volt cord, switch on circuit breaker, everything worked normal again

When I removed the unit I failed to secure the clip on wires - AND zing they went back into the insulation - now it required pulling unit out removing the back panel and placing wires thru the insulation and back into the oven - job was then very simple

Per the instructions... I just wish I had read them first... It took me 10 min longer but it all turned out right and a LOT cheaper than calling the repair man.