EDW6060L15SS General Electric Dishwasher - Instructions

Self

I removed the old valve with wrench and Philips screw driver.Unscrewed the mounting plate and water hose. When I went to replace the new water inlet valve, I found that there was a mismatch on the screw holes for the new mounting plate. Different screw threads. I tried to find screws that would fit, but didn't have any.So I manged to make the old screws re-thread themselves and hold the plate in place. I then attached the water hose and started the dishwasher up. Make sure to power off the unit then power it back on to clear and reset the programming. Works great now.

My part came in and my husband was at work so..... I did not want to wait for him to come home to wash my clothes! I installed the motor myself and I was not even the one that took it off! It was so easy to do! Turned the washer on and bingo it was back and going! So glad I can get the parts myself and avoid the middle man and his bill!!! Hook up the drain hose with pliers and screw the motor to the frame and that's it!

I had a slow leak from vicinity of sump. I replaced sump and pump connector as these were only likely sources of leak based on parts select history. Turns out plastic tub had a fine crack. The crack was directly under the heating element which had melted the plastic and over time created this small crack that was found by a repair guy immediately. I even suspected a tub leak and searched for one but being directly under the element made it invisible to me and in an area I did not suspect (front). Oh well - also learned GE charges $100. to come to my house, show me a crack, and leave (I repaired it with epoxy).

Parts were easy to find, easy to order and arrived prior to the advertised delivery date. Instructions for replacement were easy to understand and in about 10 minutes the old part was removed, and the new one installed. thanks for your prompt and efficient company.

hubby had no prob replacing the new part!!YEA!!dishes are clean again!

Super easy..........just push it on and it should snap in place. No tools required!

I just purchased a house just before it went on foreclosure and several parts to th dishwasher was missing. I went on th internet and came upon your web site. Having no manual I thought that this was going to be abut as much fun as stepping on landmines. I was surprised that I entered the model number and was able o get all the parts hat I needed. The replacement was easy but a word to the wise sometimes on wheels they sell them with the locks that hold them to the basket and they will have the same part number. Other then that a fun experience.

Remove bottom articulating sprayer and water fittings. Remove and replace filter

just snapped the new part in. couldn't have been easier

After finally getting the door open and opening it up, the problem became apparent. Partselect helped me locate the part. it came quickly, and the repair was simple. It took me two trys to discover how the spring fit, but once I looked closely at the diagram, it was a cinch. I was a very proud dishwasher owner!

I used needle nose pliers. I bent the stainless steel guide arm out so that I could insert the end cap. Once the end cap was installed I used the same needle nose pliers to "pinch" the guide arm back tight around the end cap. The end cap had premanufactured "notches" to hold the end cap in place once the guide arms are pinched down.

Remove top rack stops, slide out upper rack from rack railing, turn over upper rack and attach spray arm using spray arm bearing and screw. Reassemble in reverse order.

Removed top screws to allow the ability to remove control dishwasher control unit. Remove door parts & be careful how you remove them & put back the door parts the same way.

Removed screws that held dishwasher under cabinet...pulled out DW...removed old part...replaced with new....easier than falling off a stump.