EDW3000G01BB General Electric Dishwasher - Instructions

I removed the old cap and put on the new cap.

Removed the old rack and slid in the new rack.

Replace all four upper basket rollers as well as the slide rail end caps.

After some investigation on the internet and partselect.com, ordered and replaced the piston and nut assembly inside the back of the dishwasher and the problem was fixed.

Took old ones off, put new ones on. It took longer to open the box

Yours guys are the best I received the parts next day thanks

First, remove the bottom front covers (two parts four screws). Second, remove the two screws at the top that secure the dishwasher to the counter. Third, gently pull away the dishwasher from underneath the counter just far enough to see and be able to remove the door spring(s) - one on each side. Fourth, remove the existing hinge arm link(s) if not already broken off, replace with the new one(s). Note that the door hinge goes on the door (front) side of the spring and the other side fits into a groove on the door arm - the other end of the spring attaches to one of the 3 available holes on the frame at the bottom. It would be a good idea to replace the hinge arm links on both sides even if only one is broken. Make sure that the door has the right tension (each spring can be hooked in 1 of 3 holes to adjust the tension). Then gently push the dishwasher back under the counter. Finally, replace the screws under the counter and replace the covers on the bottom front. All of this should take no more than 15-20 minutes. This was an easy job!

Pop off End Caps with pliers. Slide Upper Dish Rack out of dishwasher. Pop off "interior" End Caps with pliers. Slide out Upper Rack Slides. Slide in new Upper Rack Slide just past second roller guide snap on new End Caps. Slide upper dish rack back into place. Snap on new End Caps.

The top rack needed to be replaced as the wheels had broken. I ordered wheels but then found that the rack had broken and the wheels would not work so I ordered a new rack. I popped off the end caps on the slides with pliers. I pulled the old rack out and slide the new rack on. Very easy. I am very happy with the way everything went with the order from Parts Select to the installation. I ordered the rack at 5 pm on the 14th and I got it on the 16th. Very good service on that and also on a return problem that they took care of.

Remove the upper rack. Removed rail end caps. Removed old broken wheels. Only reason I needed pliers was that one wheel was stuck from old age. Snapped the new wheels on easily. Installed new end cap. Good as new. Great delivery speed of parts. Thanks.

I took the dishwasher out from under the sink and looked at the pump and motor, saw that the cooling fan that this old style motor used was broke. Ordered this kit and installed it. I didn't even look at the directions that simple of a swap. Thank God!

removed rack and installed new ones easily. Appreciated the fast service that I received when ordering the new parts!

(1) Remove end caps of the support arms that hold the upper rack in place (use pliers if needed). (2) Pull rack completely out of dishwasher. (3) If some of the old rollers have broken off in the support arms, remove them by sliding them forward. (4) Remove rollers (or broken-off stubs) from the sides of the rack (use pliers if needed). (5) Push new rollers onto the sides of the rack (hand pressure should be sufficient). (6) Insert rack back into the support arms by sliding the new rollers into the support arms. (7) Replace end caps; make sure they are secure.

I was having a difficult time locating a new silverware basket. Found your website, chatted with a representative. Gave a brief description and your representative found it right away. It was inexpensive and was shipped and received in 3 days! Awesome service from start to finish. Thank you.

Snapped new one on in about 30 seconds