EDW30 Dishwasher - Instructions

It was very easy to attach the wheel after viewing the video on the part I order from partselect.com. Thank you for the help!!

Dishwasher is 22 years old and I'm 80 years old so it took longer, about 3 hours. After removing, turned upside down and removed old pump-motor assembly and replaced with new following directions [which took a little while to figure out; my assembly was quite a bit different from the replacement pump-motor]. Pleasantly surprised at how quiet the dishwasher now runs. Normally I would replace this old an appliance, but this unit has provision for inserting a wood panel that blends with the cabinets and a new GE dishwasher with this feature costs $1300 MSRP. I'm trying to save money for when I get old so I decided to do the repair myself. For $150 it was a worthwhile investment.

Instead of purchasing a new dishwasher, I elected to replace the motor/pump assembly which the existing was noisy and leaking water. To start to took pictures of the existing assembly and marked the wiring connections. I read the instructions a few times until I fully understood and had the necessary parts identified. The only problem was the bracket that holds the solenoid has two holes for mounting the drain feedback bracket were not threaded. I was able to tap the holes (metric) and mount the bracket. Caution must taken not damage the solenoid coil.

Merely pushed the baffle into the slots in the lower right corner and the leak stopped.

Dishwasher had flooded. Removed Dishwasher from cabinet and diagnosed problem. Found "PartSelect" on Internet and found Part kit available at reasonable price, in stock to ship immediately. Part #PS260801 [WD26x10013] contained enough parts to make installation easy and also I was able to cure discovery of slit in drain hose that attached to dishwasher drain outlet because kit included a short piece of hose and a hose clamp that allowed hose that had been trimmed to connect to outlet.

By GE dishwasher badly leaked under load. I was about to shop for new dishwasher ($400 ?) when I had found your website. With likely reason identified, inexpensive parts readily available and video instructions being very clear, I had decided to try to fix my dishwasher myself. Parts arrived on schedule and I had replaced my old corner baffles in 1 minute with no tools at all. It fixed the problem with my dishwasher with minimal trouble for me for less than $30. Thank you.

Immediately shut off water supply to the washer. After ordering and receipt ot part: Removed base panel, turned off power, disconnected wire, water supply line and screws attaching washer to kitchen counter. Pulled the washer out and turned it on its side with the valve on top. Removed and replaced the valve, returned the washer to the upright position, pushed it back under the counter, reconnected all services, screws to counter and base panel, turned on the water and power. Took two hours since I needed take a trip to the hardware store to replace a right angle water fitting .

Took of the plactic strainer shroud unscrewed the piston nut assembly by hand installed the new one it takes longer to remove the shroud than it does to replace the part

Briefly, after a power outage...detergent door wouldn't close,and when washer was started would cycle over and over without stopping. Thought control module & door motor were at fault. As it turned out, due to the variable power changes the control module wouldn't reset properly and kept cycling. I opened the washer and removed the inner liner, re-positioned the door arm on the motor, re-assembled liner and closed. Plugged unit in and put door lock in locked position..which activates unit. Heard detergent door motor resetting, and the control module reset properly to normal-heated dry position. The fact is that knowledge of the operating procedures could save hundreds in parts and repairs by trouble shooting the system before ordering parts.

Researched the repair solution online, ordered the part from Parts Select that was way less expensive then the manufacture and 2 other parts sites. Very easy to fix. Saved $$$ and time! Love It

Replays the wheel

Watched the how to video, ordered part, part arrived 5 days later. Popped out end caps. Took out rack, replaced wheels and boom less than a minute later it was fixed. Now my kids can do the dishes safely. Momma has a way out of doing dishes now.

Original parts broke off at the wheels and wouldn't stay attached to the basket when pulled out for use...replacement was simple strait forward...remove the old, and on with the new.

Insert the piece into wheel and snap on lower rack of dishwasher. Thank you to parts select for such fabulous service and quick delivery and fair price.

Had just a little trouble getting the end caps of the the runner bars after that it was a breeze, I am a 55 year old woman and done the job by myself