EDW1500G00CC General Electric Dishwasher - Instructions

I removed the old corner tub baffle's and replaced them with the new one's and that took care of the problem. I used a putty knife to remove the old one's and put some new adhesive on and put the new ones in place and let them set up for two days to let them really set up and they work really good no leaks.

I removed the sump cover and it was disgusting! This was the first thing I did to trouble shoot. I tried cleaning the cover but it was just too dirty. I ordered a new part and now I don't have any more water pooling at the bottom. I unscrewed the cover and then screwed on the new one. It did not come with screws so keep your original screws.

Remove front shields on bottom of dishwasher. Shut off dishwasher and electricity. Unplug electric connection. Unscrew brace holder screws on front. Remove clamped on hose at back of valve. Unscrew valve from copper water pipe. Screw on new valve to copper water pipe. Put on clamped hose. Screw on bracket. Plug in electric connection.

used tips from a past buyer

whole assembly screws out, replacement was a breeze. I love this site. Parts came quick

Put rack in place and snapped new one in.

Quick and easy...a 7 yr old could have done it.

We removed old gasket, cleaned surfaces and installed new gasket.

I removed the plastic inner door liner, removed the timer assembly. Replaced both plastic parts, Detergent cup release arm and dispenser release timer lever. The most difficult part was reassembling the timer lever spring. Long nose pliers made it simple. Works like new.

Turn off the power at the breaker panel. Turn off the water supply that goes to the dishwasher. Remove the front lower panel to gain access to disconnect the water line and electric. Now remove the two screws that connect the dishwasher to the countertop. You should be free to slide the dishwasher from under the countertop far enough to remove the drain hose. Slide the dishwasher out all the way and lay on the floor door down. Loosen the two clamps that hold the motor up. Remove the motor bracket, (should only be one screw. Disconnect the wires from the motor. Now just pull the motor down and out. Repeat the process to install the new motor. I took several pictures before I started removing anything. The instruction that comes with the kit is very good. Their will be parts in the kit that will not be used. Not to worry!

I popped out the stoppers at the end of the gliders. removed broken rollers and slid on new rollers.re-installed stoppers, tested all functions. tested good

Replaced the Piston and Nut Assembly! Removed rear strainer by removing four screws. Unscrewed the assembly using a large handled pliers for leverage, cleaned the threads and installed the new one with my hand. I then put the strainer back in using the same four screws. I also replaced the Lower Spray Arm with Tower because a tab on the assembly was broken. I used the same long handled plier to carefully turn the assemble out. I put the new one in by using only my hand to screw it in.

I looked on Part select at the model number of the dishwasher. I looked at the diagram of the diswassher and the hose. I read some of the repair stories. And became sure the upper hose was my problem and was armed with the ability now to fix my machine. Thanks PartSelect

Pop out the old baffles with the help of a screwdriver, push in the new parts in their places and done.

We watched the video describing the replacement process, cleaned the groove after removing the old gaskets, and installed the new gaskets as sown in the video. The installation passed the test washing a full load after the job.