E23CS75DSS1 Electrolux Refrigerator - Instructions

followed steps posted on site

This is an easy repair. Unplug appliance. Remove the old water valve by unscrewing it from the frame of the refrigerator. Disconnect the cables and all the water hoses. The hose fittings are a different type: clip off the old connectors from the hose ends and push the hoses straight into the new connectors till they fit solidly. Reconnect the cables and screw the valve back onto the frame of the refrigerator.
Unfortunately, my leak was from a hose, not the valve, so this didn't actually fix it.

Took the door off and pulled out old part and then pushed in new part. The best part of it was locally the parts house wanted $40 for the part. I bought it heare with shipping for $5. You Rock

took existing water valve loose, removed plastic water lines and reinstalled on new valve and installed new valve into refrigerator

Getting the old one out was not to hard. Putting the new actuator in was a littel more difficult. There is a small nipple that makes it hard to get the actuator over and slip down in to the cradle. After that you have to use needlenose pliers to get the water line back in to the outlet hole. It's better to a second person help you hold the unit while you are putting the water line back in.

Remove two bolts holding bracket keeping the door mounted on top of the refrigerator, remove mounting bracket. Lift off door, invert and remove bits of old damaged bearing. Insert new bearing into holder on door at bottom an refit door on to body. Replace bracket on top of refrigerator. That's all

I followed the excellent directions in the video linked to the email from PartSelect. The installation was quick and easy. I rated the whole operation "a bit difficult" because, if I had seen the video before I removed the old part, I would have known that you tap the support's center rod gently INTO the wall instead of wrestling it violently OFF the wall.

Started researching for the part. Watched the video on how to replace bearing. Ordered it and 3 days later the door now works like it should. Thanks to Partselect and the how to video it was easy!

removal of the old valve to identify the problem took the most time. Once the new valve came it it was easy. NOTE: the old one had threaded connectors, and the new one is press/fit so the ends of the tubing need to be cut. The color coding and size matching are great.

took door off ,replaced the hinge,and put door back on....

After taking door off, I found the door closure/hinge bearing was broke. I got manual out, looked up part number, googled it, and ordered the part from this website. Couldn't be happier!! My wife is really happy too, such an easy fix

Read the other stories which were really helpful. It is a fairly simple project as long as you don't disconnect the water line as others said. I had a somewhat difficult time getting the ears of the actuator in the slots but eventually went right in.

I removed the door and replaced the broken hinge bearing with the new part and the door works great!

it was a simple fix, all i had to do was remove 3 small bolts from top of door, set door aside remove 1 screw that holds door cam in place, install new door cam.hole job took about 15 minute's.

Couldn't have been an easier. Removed the screw/nuts from the top of the fridge door that held the door in place and removed the door. Unscrewed the holder at the bottom, replaced both parts and put the door back together. It took me longer to get everything out of the fridge door than to replace the parts. EASY AS COULD BE!!!