DW700W Jenn-Air Dishwasher - Instructions

Replaced door seal, very easy!

Opened the box and put the new Silverware Basekt in the Dishwasher. Everything was atttached, no labor involved. Loved it, wish I had thought about ordering it earlier. Ordering, Receiving and Installing was EASY and QUICK. Thank You!

Removed the upper rack rail stops. Removed the upper rack by pulling outward until the rack rollers cleared the rails. Attached the new roller on the upper rack. You can look at the other undamaged rollers to see how they lock into place. re-install the upper rack by feeding the upper rack rollers back onto the rails. Install the rail stops back into the rail ends,and the job is complete. VERY EASY!

I had to call an appliance repairman to come fix it. If I would have been able to pull the dishwasher out, it would have been a simple fix. It would not come out and I loosened to water line trying therefore causing more problems.

WE installed a new door gasket. However the machine still had a leak only on the left side. Called a tech and he came and said the gasket was installed backwards. Apparently the original one was also because we installed the new gasket exactly the way the old one was. We are all set now.

ordered the basket and put it in its place.

Turned off the supply valve. Disconnected the power. Removed the water inlet and outlet lines. Removed the old valve. Installed the new valve and reversed the previous action. Installed a new outlet clamp on the hose (highly recommended).

I ordered the basket on Sunday and received it on Tuesday. It is a better basket than what originally came with the dishwasher. Very happy with the prompt delivery and service.

Exactly like the video...everything went well

Opened circuit breaker feeding dishwasher Removed the 10 screws from the inside panel on the door. Unplugged two quick disconnect plugs. Removed the wax motor (actuating solenoid). Installed the new one from Parts Select. Reconnected the plugs. Replaced the cover and 10 screws. Turned the breaker on and ran a load of dishes. worked perfectly.

replaced hose

Pulled the old gasket. Cleaned gasket channel very well. Centered middle of new gasket with the door latch. Then worked gasket in both directions to both ends. Closed the door and left with door tight for several hours to allow it to seat with the new gasket. When use was resumed the leak, at least to this point, has stopped.

remove panel on front to acess float @ float switch.Remove phillips screw to float switch,remove palnut from float shaft with 5/16 nutdriver.Remove float from inside washer.Reinstall new parts reverse order.

Real easy. I checked out the instruction video. It was great no problem making the repair....Thanks

Unscrew round keeper on top of spray arm -CCW. Lift off spray arm. Remove the six Torx head screws aroun pump housing. Lift off pump housing. Unplug unit and obtain a small piece of 2 x 4 wood to block up the motor underneath. Push the white plastic lever near the left side of motor towards the back to loosen the entire unit. Place the wood block uner the motor and you will see the seal is accessable inside the dishwasher. Remove the seal and very carefully clean the area that accepts the new seal. Remove the block and pull back on the white plastic lever. Done!