DU1145XTPBA Whirlpool Dishwasher - Instructions

My main fear was finding the part and not knowing my dishwasher model without looking it up in the owner's manual. Imagine my joy to find the part color-coded on the website and extremely easy to find!!!

Followed the video tutorial and repair was a breeze.

Repair was easy. After readjusting the dishwasher so that it wasn't leaning forward (it still leaked) I replaced the Door Gasket. Pulled one end out about 2 ft and pushed in the new one as I pulled the old one out and pushed the new one in. Came out and went in easy, just used a big screw driver to slighting push the new gasket in to make sure it fit snug. Fit, Form & Function was all correct. Works like a sharm, no more leaks and door does fit snug when closing. All good.

Removed front panel for access to the back of the soap dispenser. Visually inspected the diespenser, and it looked okay. Ordered new electronic control board and bi-metal fuse from PartsSelect to address the no-power situation. The parts arrived in 2 to 3 days. Once the dishwasher's front panel is again removed, the control board and fuse are right there for easy access. The control board snaps out easily. All attaching wires unplug easily. All the wires are plugged into the new control board. It's easy, and they cannot be mixed up.Snap the control board back into place.The fuse can be unpluged and easily tested with a continuity tester or multimeter.If it's bad,the lead wires are cut, and the new fuse is easily spliced in. Reattached the front panel, and everything worked perfectly.

read other accounts of customers at parts select and decided that this would solve my problems as well. Recieved new parts in timely manner and fumbled through the project in well under 2 hours! Simply remove lower spray arm, pull disher washer out of cabinet and lie on side with door open. Disconnect any wiring and parts not on the new assembly, pull three plastic retaining clips and take pump housing assembly out from inside cabinet. Reverse proceedure and listen to a whisper quiet dishwasher and a very happy wife.

It was very easy to replace the part in the bottom basket of the dishwasher, it was easy to find the part on your website due to the great schematic visuals. Thank you, B. Arias

Repair was simple. Pulled out the old gasket and pushed in the new one.

Ordered Rinse Aid Cap and received the next day. Placed in the dishwasher Rinse Aid Cap position and locked in. A perfect fit.

Unhook electrical/water supply, removed dishwasher, flip upside down, Remove wire connector from motor, remove bolt from motor, turn motor and remove, install new motor in reverse process.

Pulled Dishwasher out, turned off power. Did not have to disconnect any hoses or electrical, because when I did the original installation, I left plenty of slack, so as to be able to pull it out. Next, tipped it on it's side, unplugged the harness, undid the bolt, turned motor 1/4 turn, pulled it out. To, re-install, just reversed the process. About 1 hour.Followed Excellent instructions on video. Was very impressed with delivery time. Only about 30 hours, from the time I ordered, to receiving part. Reg. ground.

Ordered the gasket on line. Received gasket in 3 days. Removed old gasket by pulling out in one piece. Pressed the new one in with my fingers and it fit perfectly and now have no leaks. Very easy fix.

Pulled out, put on it's side. Take pump off and put new one on and put all back together. Very easy. Video was helpful also.

After inspection I found the rubber seals on the feed tube for the upper rack to be worn. At that point I thought that was it. I ordered the feed tube assembly the upper rack seal and the lower spray arm support hub as the bottom of the existing hub was worn. Installed all parts and same issue. Researched again on parts select and checked food chopper and it was clogged and broke off. Ordered and it works great. About 100.00 for parts and total time 1 to 1.5 hours as I worked on it three times. Down time about one week. This model is a Whirlpool Superba with the closest replacement about 1000.00 Thanks PART SELECT

The service video was great. This is a great product web site and service.... Thank you

Just had to take several screws out of old panel on dishwasher. Used the same screws to put on the new stainless panel. No wires to disturb. Was very easy. Works like a charm. Thank you Parts Select.