DSS26DHWCSS General Electric Refrigerator - Instructions

Temp. Sensor was under an egg shaped cover on the left side wall in the refrigerator. Remove the cover, cut the two wires to the old sensor and remove it. Connect the new sensor to the two wires using butt connectors. Replace cover and done.

I followed the instructions from this manual . I was a little concerned that I might break the new stripper arm. But after removing the old arm I was able to practice the technique and installed the new arm with no problems.

I watched the video of the repair, and followed their procedure. First turned off ref. removed trays, removed light and then back panel. located defrost heater at bottom of condensing coils. Removed and replaced. reassembled and ref. works great. Thanks ross

Ordered part using the schematic, it got here the next day!! Took out the ice bin, using the 2 butter knives, I pried the side clips and slipped the dispenser out, , I removed the broken plate, and carefully threaded the auger into the hole of the new plate, slid it into the dispenser and seated clips, placed back into ice bin and attached the 3 screws on the bottom to hold in place! A 70 yr old lady repairman, who would have thought it.

Refer model was older than repair instructions given for job. So the repair could have been done by simply unclipping the forward auger gear box & pulling it up and out of the ice tray unit. However we had to figure that out for ourselves & the gear box resisted most attempts @ prying it out. It eventually gave (with no breakage) & it was then easy to pull the auger from the rear housing & replace the drive cup. With all items refitted together the gear box slipped easily back into the tray housing & the auger w/ new drive cup slipped into it's rear housing.